40-2-10 ITW Chemtronics, 40-2-10 Datasheet - Page 2

• Manufacturer Part Number: 40-2-10
• Description: SOLDER-WICK LEAD-FREE 10' 0.06"
• Manufacturer: ITW Chemtronics
• Series: Soder-Wick® LFr
• Type: Lead Freer

Specifications of 40-2-10

• Width: 0.060" (1.52mm)
• Length: 10' (3.048m)
• Color: Yellow
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ITW CHEMTRONICS
SECTION 10: STABILITY AND REACTIVITY
Stability - This product is stable.
Incompatibility: Do not mix with powdered alkali and alkaline earth metals or strong oxidizing agents.
Products of Decomposition: Carbon dioxide, carbon monoxide.
Hazardous Polymerization: Will not occur
Conditions to Avoid: NA
SECTION 11: TOXICOLOGICAL INFORMATION
Inhalation:
Inhalation of dust and fumes during desoldering can irritate the respiratory tract and cause respiratory sensitization.
Ingestion:
Not a typical route of exposure.
Skin:
May cause skin sensitization in some individuals.
Eye:
Contact with rosin dust and desoldering fumes can irritate the eyes.
Cancer Information: No ingredients listed as human carcinogens by NTP or IARC
Reproductive effects: none
SECTION 12: ECOLOGICAL INFORMATION
Environmental Impact Information
No environmental impact is anticipated if product is disposed of according to all federal, state and local regulations.
REPORTING
US regulations require reporting spills of this material that could reach any surface waters. The toll free number for the US Coast Guard National Response Center is:
1-800-424-8802
SECTION 13: DISPOSAL CONSIDERATIONS
Dispose of in accordance with all federal, state and local regulations.
SECTION 14: TRANSPORTATION INFORMATION
Air:
Ground:
SECTION 15: REGULATORY INFORMATION
SECTION 313 SUPPLIER NOTIFICATION
This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know
Act of 1986 (40 CFR 372).
Chemical Name
Copper
This information should be included on all MSDSs copied and distributed for this material.
TOXIC SUBSTANCES CONTROL ACT (TSCA).
All ingredients of this product are listed on the TSCA Inventory.
WHMIS: Not hazardous. This product has been classified according to the hazard criteria of the CPR and the MSDS contains all of the information required by the
CPR.
SECTION 16: OTHER INFORMATION
Product should be used only with adequate ventilation. Mechanical ventilation is recommended on all soldering stations. If such ventilation is not available, personnel
should wear NIOSH approved organic vapor respirators equipped with particulate dust filters specified for use during welding or soldering.
To the best of our knowledge, the information contained herein is accurate. However, all materials may present unknown hazards and should be used with caution. In
particular, improper use of our products and their inappropriate combination with other products and substances may produce harmful results which cannot be
anticipated. Final determination of the suitability of any material is the sole responsibility of the user. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that may exist.
Shipping Name
Conditions to Avoid: None known
Proper
Wire
Wire
Teratogenic effects: none
Not regulated
Not regulated
Page 2 of 2
CAS#
7440-50-8
Mutagenic effects: none
Wt. % Range
98.0-99.0
MSDS #1404