A22L-CR Omron, A22L-CR Datasheet - Page 27
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
A22L-CR
Manufacturer Part Number
A22L-CR
Description
SWITCH UNIT PB SQUARE/PROJ RED
Manufacturer
Omron
Type
Actuator, Pushbutton, Squarer
Series
A22r
Specifications of A22L-CR
Accessory Type
Projection Type Operational Unit
Color
Red
Illumination
Not Illuminated
Cap Color
Red
Length
29.8 mm
Mounting Style
Panel
Width
29.8 mm
For Use With/related Products
A22 Series
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
A22 Series
Other names
A22LCR
Securing the Connector Cable
1. Insert the connector into the cable port hole in the Box and secure
2. Open a hole in the thin rubber section of the rubber ring.
3. Pass the tightening cap through the cable, insert the cable into the
Switch Blocks
Installing the Switch Blocks
Fixing nut
• Hook the small protrusion on the Switch Block into the groove on
the Mounting Latch on the other side of the lever, then push up the
Switch Block in the direction indicated by the arrow in the figure
below.
with the fixing nut inside the box.
connector, and tighten the hexagonal nut to secure the cable.
Inside
Cable diameter
9 to 11 dia.
Box
7 to 9 dia.
Mounting
Latch
Rubber washer
Outside
Connector
Tightening cap
Switch Block
A22Z-3500-1
A22Z-3500-2
Connector
Protrusion
Lever
Cable
Removing the Switch Blocks
Wiring
Wiring Round Crimp Terminals
Engraving
• Insert a screwdriver between the Mounting Latch and the Switch
• Loosen the terminal screw from the Switch Unit until it completely
• Engrave the characters on the surface on the
• The characters must not be engraved deeper
Block, then push down the screwdriver in the direction indicated by
the arrow in the following figure.
comes off the groove, insert a screwdriver as shown in the following
figure, then push up the washer in the direction indicated by the
arrow to temporarily secure it. Now, a round crimp terminal can be
connected. After inserting the terminal, tighten the screws to
complete wiring.
Cap. Make sure that the characters are
aligned parallel to the imaginary line
connecting the two protruding portions to the
left and right of the Cap.
than 0.5 mm. Apply an alcohol-based paint
coating, such as melamine, alkyd, or acrylic
resin paint coating, to the engraved
characters.
Washer
Screw
Use either of the following screwdrivers.
Flat-head
screwdriver
Phillips
screwdriver
3 to 6 mm
3 to 6 mm
Screwdriver
Screwdriver
Protruding portions
on Cap
A22
27