GB215AB-B NKK Switches, GB215AB-B Datasheet - Page 2

• Manufacturer Part Number: GB215AB-B
• Description: SW PB SPST PLNGR WH STR BRKT PCB
• Manufacturer: NKK Switches
• Series: GB2r
• Type: Standardr

Specifications of GB215AB-B

• Circuit: SPST-NO
• Switch Function: Off-Mom
• Contact Rating @ Voltage: 0.4VA @ 28VAC/DC
• Actuator Type: Rectangular Button
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Illumination Type, Color: -
• Illumination Voltage (nominal): -
• Other names: GB215AB-B-RO; GB215AB-B-RO

General Specifications
NKK Switches • email: [e-mail] • Phone [phone] • Fax [phone] • www.nkkswitches.com
Electrical Capacity (Resistive Load)
Other Ratings
Materials & Finishes
Environmental Data
PCB Processing
Standards & Certifications
Operating Temperature Range:
Nominal Operating Force:
Flammability Standards:
Insulation Resistance:
or CSA Certification:
Stationary Contacts:
Contact Resistance:
Dielectric Strength:
Movable Contacts:
Mounting Bracket:
Mechanical Life:
UL Recognition
Electrical Life:
Logic Level:
Soldering:
Terminals:
Vibration:
Humidity:
Cleaning:
Actuator:
Travel:
Shock:
Case:
Base:
Manual Soldering: 4 seconds maximum @ 390°C maximum.
0.4VA maximum @ 28V AC/DC maximum
(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Note: Find additional explanation of operating range in Supplement section.
80 milliohms maximum
500 megohms minimum @ 500V DC
500V AC minimum for 1 minute minimum
50,000 operations minimum
50,000 operations minimum
1.0N
Pretravel .020” (0.5mm); Overtravel .023 (0.6mm); Total Travel .043” (1.1mm)
Glass fiber reinforced polyamide (UL94V-0)
Glass fiber reinforced polyamide (UL94V-0)
Phosphor bronze with gold plating
Brass with gold plating
Glass fiber reinforced polyamide (UL94V-0)
Phosphor bronze with tin plating
Brass with gold plating
–25°C through +70°C (–13°F through +158°F)
90 ~ 95% humidity for 240 hours @ 40°C (104°F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
50G (490m/s
Wave Soldering recommended. See Profile B in Supplement section.
These devices are not process sealed. Hand clean locally using alcohol based solution.
See Cleaning Specifications in Supplement section.
UL94V-0 actuator, case, & base
The GB2 Series pushbuttons have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Ultra-Thin Pushbuttons
Series GB2
2-06