A22W-2MY-6A-02 Omron, A22W-2MY-6A-02 Datasheet - Page 164

• Manufacturer Part Number: A22W-2MY-6A-02
• Description: SWITCH KNOB ILLUM 2POS DPST YEL
• Manufacturer: Omron
• Series: A22Wr
• Type: Standardr

Specifications of A22W-2MY-6A-02

• Circuit: DPST-NC
• Switch Function: 2 Position, Maintained
• Contact Rating @ Voltage: 10A @ 110VAC
• Illumination: Illuminated
• Illumination Type, Color: LED, Yellow
• Illumination Voltage (nominal): 6 VAC
• Mounting Type: Panel Mount
• Termination Style: Screw Terminal
• Panel Cutout Dimensions: 22mm (Round)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A22W2MY6A02

Mounting the Switch
The Standard-size Legend Plate Frame can be mounted. Mount the
Frame as shown in the following diagram. Mount the Switch in the
same way as for an ordinary panel.
Creating a Cable Port Hole
Place the tip of a screwdriver on the surface where the cable port
hole is to be created with the cover attached and strike the screw-
driver to punch a hole. Attempts to punch a hole on the other side of
the case will damage the Box.
Securing the Connector Cable
1. Insert the connector into the cable port hole in the Box and secure
2. Open a hole in the thin rubber section of the rubber ring.
3. Pass the tightening cap through the cable, insert the cable into
162
7 to 9 dia.
9 to 11 dia.
with the fixing nut inside the box.
the connector, and tighten the hexagonal nut to secure the cable.
Fixing nut
Control Box (Enclosure)
Cable diameter
Inside
Box
Outside
Rubber washer
Connector
A22Z-3500-1
A22Z-3500-2
Snap-in Legend Plate
Tightening cap
Connector
Cable
Installing the Switch Blocks
Hook the small protrusion on the Switch Block into the groove on the
Mounting Latch on the other side of the lever, then push up the
Switch Block in the direction indicated by the arrow in the figure
below.
Removing the Switch Blocks
Insert a screwdriver between the Mounting Latch and the Switch
Block, then push down the screwdriver in the direction indicated by
the arrow in the following figure.
Installing/Removing the Switch
Blocks
Mounting
Latch
Flat-head
screwdriver
Phillips
screwdriver
Use either of the following screwdrivers.
3 to 6 mm
3 to 6 mm
Switch Block
Screwdriver
Protrusion
Lever