G13JHCF NKK Switches, G13JHCF Datasheet - Page 2

• Manufacturer Part Number: G13JHCF
• Description: SWITCH TOGGLE ILLUM SPDT .4VA RA
• Manufacturer: NKK Switches
• Series: Gr

Specifications of G13JHCF

• Circuit: SPDT
• Switch Function: On-Off-On
• Contact Rating @ Voltage: 0.4VA @ 28VAC/DC
• Actuator Type: Standard Round
• Actuator Length: 3.80mm
• Illumination: Illuminated
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Bushing Thread: Unthreaded
• Contact Configuration: SPDT
• Switch Operation: On-Off-On
• Contact Voltage Ac Nom: 28V
• Contact Voltage Dc Nom: 28V
• Switch Terminals: Through Hole
• Actuator Style: Lever
• Switch Mounting: Through Hole
• Svhc: No
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 360-1697; 360-1697; 360-1771; G13JHCF-RO

General Specifications
Electrical Capacity (Resistive Load)
Other Ratings
Materials & Finishes
Environmental Data
PCB Processing
Standards & Certifications
www.nikkaiswitches.com • Nihon Kaiheiki • Phone [phone] • Fax [phone]
Operating Temperature Range:
Nominal Operating Force:
Insulation Resistance:
or CSA Certification:
Stationary Contacts:
Contact Resistance:
Dielectric Strength:
Movable Contacts:
Power Terminals:
Lamp Terminals:
Mechanical Life:
Angle of Throw:
UL Recognition
Sealing Rings:
Electrical Life:
Logic Level:
Soldering:
Vibration:
Humidity:
Cleaning:
Actuator:
Shock:
Case:
Base:
Manual Soldering: 4 seconds maximum @ 390°C maximum
0.4VA maximum @ 28V AC/DC maximum
(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Note: Find additional explanation of operating range in Supplement section.
80 milliohms maximum
500 megohms minimum @ 500V DC
500V AC minimum for 1 minute minimum
100,000 operations minimum
100,000 operations minimum
10,000 operations minimum @ 0.1A @ 28V AC/DC
1.30N
28°
Polyamide
Glass fiber reinforced polyamide
Nitrile butadiene rubber
Phosphor bronze with gold plating
Phosphor bronze with gold plating
Glass fiber reinforced polyamide
Phosphor bronze with gold plating
Phosphor bronze with gold plating
–25°C through +55°C (–13°F through +131°F)
90 ~ 95% humidity for 240 hours @ 40°C (104°F)
10 ~ 500Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
50G (490m/s
Wave Soldering recommended. See Profile B in Supplement section.
Automated cleaning. See Cleaning specifications in Supplement section.
The G Series toggles have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
Ultra-Miniature Fully Illuminated Toggles
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Series G
2-06