RTV162-85ML MG Chemicals, RTV162-85ML Datasheet - Page 3
![no-image](/images/manufacturer_photos/0/4/432/mg_chemicals_sml.jpg)
RTV162-85ML
Manufacturer Part Number
RTV162-85ML
Description
ADHESIVE SEAL SIL NON-CORROSIVE
Manufacturer
MG Chemicals
Series
RTVr
Type
Potting Compound, 1 Partr
Specifications of RTV162-85ML
Product
Silicones
Size
2.8 oz
Application
Bond capacitors, resistors and integrated circuits to PCBs seals exposed wires, faying surfaces, connectors
Chemical Component
Silicone
Color
White
Dielectric Strength
19.7 KV⁄mm
Dispensing Method
Tube
Elongation
400%
Hardness
35 (Shore A)
Primary Type
Adhesive
Special Features
Non-Corrosive
Specific Gravity
1.09
Standards
UL Recognized
Temperature Range
-60 to +205 °C
Temperature, Rating
-60 to +205 °C
Tensile Strength
3.73 MPa
Thermal Conductivity
0.21 W⁄m.°K
Time, Cure
2 Days
Time, Setting
4 hrs.
Viscosity
350 g⁄Minute
Volume Resistivity
3 x 10^15 Ohm.cm
Weight
2.8 Oz.
Main Industry
Electronics
For Use With/related Products
Non Corrosive
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
NOTE TO PHYSICIAN
5. FIRE-FIGHTING MEASURES
FLASH POINT:
METHOD:
IGNITION TEMPERATURE:
FLAMMABLE LIMITS IN AIR - LOWER (%):
FLAMMABLE LIMITS IN AIR - UPPER (%):
SENSITIVITY TO MECHANICAL IMPACT:
SENSITIVITY TO STATIC DISCHARGE
EXTINGUISHING MEDIA
SPECIAL FIRE FIGHTING PROCEDURES
6. ACCIDENTAL RELEASE MEASURES
ACTION TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
STORAGE
RTV162 12C-Crtrg (0.725LBS-0.329KG)
POLYDIMETHYLSILOXANE SEALANT
Treatment is symptomatic and supportive.
Sensitivity to static discharge is not expected.
All standard extinguishing agents are suitable.
Firefighters must wear NIOSH/MSHA approved positive pressure self-contained breathing
apparatus with full face mask and full protective clothing.
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wear proper protective
equipment as specified in the protective equipment section. Increase area ventilation.
Keep container closed when not in use. Avoid contact with skin and eyes. Remove contact lenses
before using sealant. Do not handle lenses until all sealant has been cleaned from the fingertips, nails
and cuticles. Residual sealant may remain on fingers for several days and transfer to lenses and
cause severe eye irritation. Product releases methanol during application and curing. Keep away from
children.
Store away from heat, sources of ignition, and incompatibles. Keep container tightly closed.
Page 3/8
> 93.3 °C; 200 °F
estimated
450 °C; 842 °F
No data available
No data available
No
Material Safety Data Sheet
Version: 1.5
10/29/2007