RTV118-85ML MG Chemicals, RTV118-85ML Datasheet - Page 3

• Manufacturer Part Number: RTV118-85ML
• Description: ADHESIVE SEAL SIL TRANS FLOWABLE
• Manufacturer: MG Chemicals
• Series: RTVr
• Type: Potting Compound, 1 Partr

Specifications of RTV118-85ML

• Features: Self Leveling
• Product: Silicones
• Size: 85 mL
• Application: Excellent for thin section potting, filling small surface voids, self leveling and protective coatings
• Chemical Component: Silicone
• Color: Clear
• Dielectric Strength: 16 KV⁄mm
• Dispensing Method: Tube
• Elongation: 325
• Hardness: 25 (Shore A)
• Primary Type: Adhesive
• Special Features: High Performance
• Specific Gravity: 1.05
• Standards: UL Recognized
• Temperature Range: -60 to +205 °C
• Temperature, Rating: -60 to +205 °C
• Tensile Strength: 2.2 MPa
• Thermal Conductivity: 0.21 W⁄m.°K
• Time, Cure: 7 Days
• Time, Setting: 20 min.
• Viscosity: 20000 cps
• Volume Resistivity: 6 x 10^14 ohm · cm
• Weight: 85 ml
• For Use With/related Products: Multi-Purpose
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5. FIRE-FIGHTING MEASURES
FLASH POINT:
METHOD:
FLAMMABLE LIMITS IN AIR - LOWER (%):
FLAMMABLE LIMITS IN AIR - UPPER (%):
SENSITIVITY TO MECHANICAL IMPACT:
SENSITIVITY TO STATIC DISCHARGE
EXTINGUISHING MEDIA
SPECIAL FIRE FIGHTING PROCEDURES
6. ACCIDENTAL RELEASE MEASURES
ACTION TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
STORAGE
RTV118 12T-Tube (0.770LBS-0.350KG)
FLOWABLE ACETOXY SEALANT (translucent)
Sensitivity to static discharge is not expected.
All standard extinguishing agents are suitable.
Firefighters must wear NIOSH/MSHA approved positive pressure self-contained breathing
apparatus with full face mask and full protective clothing.
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wash walking
surfaces with detergent and water to reduce slipping hazard. Wear proper protective equipment as
specified in the protective equipment section.
Product releases acetic acid during application and curing. Use only in well-ventilated areas. Avoid
contact with skin and eyes. Remove contact lenses before using sealant. Do not handle lenses until
all sealant has been cleaned from the fingertips, nails and cuticles. Residual sealant may remain on
fingers for several days and transfer to lenses and cause severe eye irritation.
Store away from heat, sources of ignition, and incompatibles. Keep out of the reach of children. Keep
container tightly closed.
Page 3/8
ca. 72 °C; 162 °F
closed cup
Not applicable
Not applicable
No
Material Safety Data Sheet
Version: 1.7
10/31/2007