MT5600BA-V92-GB/IE Multi-Tech Systems, MT5600BA-V92-GB/IE Datasheet - Page 29

• Manufacturer Part Number: MT5600BA-V92-GB/IE
• Description: MODEM V.92 DATA/FAX WORLD
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® IIr

Specifications of MT5600BA-V92-GB/IE

• Data Format: V.92
• Interface: RS-232
• Voltage - Supply: 9 V ~ 12 V
• Mounting Type: Desktop
• Package / Case: 9.0" L x 6.2" W x 1.4" H (229mm x 158mm x 36mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1059

This chapter describes how to use the MultiModem II modem on a leased line.
A leased line is a private, permanent, telephone connection between two points. Unlike normal dialup
connections, a leased line is always active. The modems automatically connect when they are attached
to the line and are turned on. Because a leased line is always active, one of the two modems on the line
must be configured as the originate modem and the other as the answer modem; it does not matter which
is which.
In the event of an interruption, leased line modems automatically reconnect when the data line or power
is restored. The modem also supports dial backup, which enables the modem to automatically switch to a
dial-up connection if the leased line goes down.
The modem supports both two-wire and four-wire leased-line operation.
Two-Wire / Four-Wire Setup
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
Chapter 4 - Leased Line Operation
1. For leased line operation, plug one end of a two-wire phone cable into the modem’s LEASED
2. Turn on the modem.
3. Starting at the STATUS LCD, press the following buttons on the front panel:
4. If the CURRENT SETTING= LCD shows ASYNC AT, press
5. Press the Enter button to select normal asynchronous operation.
6. The OPTION SET LCD appears. Press
7. Press
8. Choose one of two actions:
9. The OPTION SET LCD appears. Press
10. This completes the setup for two-wire leased line operation. Upon completion, the modem
jack. Connect the other end to a leased line wall jack or terminals.
anything else, press
exit to the CURRENT SETTING= LCD to verify the selection.
attempts to connect to the modem at the other end of the leased line. If the remote modem
has not yet been configured for leased line operation, you may turn off the local modem until
the remote one is ready.
. The CURRENT SETTING= LCD appears.
•
•
To set up the modem as the originate modem, press the Enter button.
To set up the modem as the answer modem, press
LEASE? ANSWER LCD, and then press the Enter button.
Note:
modem, and the other as the answer modem, but it does not matter which is which.
,
,
One of the modems in a leased line pair must be configured as the originate
,
to go to the ASYNC, NORM? LCD.
,
,
,
. The 2 WIRE LEASE? ORIG LCD appears.
 to exit to the SYNC/ASYNC OPTIONS LCD.
 to exit to the ONLINE OPTIONS LCD, or
Chapter 4 – Leased Line Operation
 and go to step 7. If it shows
to display the 2 WIRE
,
,
,
,
to
29
,