CDMG15008-03A CUI Inc, CDMG15008-03A Datasheet - Page 4

• Manufacturer Part Number: CDMG15008-03A
• Description: SPEAKER 8 OHM .3W 15MM ROUND
• Manufacturer: CUI Inc
• Series: CDMGr
• Type: Magneticr

Specifications of CDMG15008-03A

• Frequency Range: 900Hz ~ 20kHz
• Impedance: 8 Ohm
• Size / Dimension: 15mm Dia x 2.8mm H
• Sound Pressure Level: 92dB
• Power - Rated: 0.3W
• Power - Max: 0.5W
• Termination: Solder Pads
• Material - Cone: Mylar
• Shape: Round
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Material - Magnet: -

Mechanical Characteristics
Item
Solderability
(Connector Excepted)
Lead Wire Pull Strength
Vibration
Drop Test
Environment Test
Item
High temp. test
Low temp. test
Humidity test
Temp. cycle test
Phone: [phone]
Fax: [phone]
Test Condition
Stripped wires of lead wires are immersed in
rosin for 5 seconds and then immersed in
solder bath of +270 ±5°C for 3 ±0.5 seconds.
The pull force should be applied to double lead
wire:
Horizontal 3.0N (0.306kg) for 30 seconds
Vertical 2.0N (0.204kg) for 30 seconds
The speaker should be measured after applying
a vibration amplitude of 1.5 mm with 10 to
55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part will be dropped, contained inside a
normal box, from a height of 75 cm onto a 40
mm thick wooden board 10 times.
Test Condition
After being placed in a chamber at 85°C for
8 hours.
After being placed in a chamber at -20°C for
96 hours.
After being placed in a chamber at +60°C and
90% relative humidity for 240 hours.
The part shall be subjected to 5 cycles. One
cycle will consist of:
Part No: CDMG15008-03A
Description: micro dynamic speaker
www.cui.com
20050 SW 112th Ave.
Evaluation Standard
Evaluation Standard
90% min. stripped wires will be
wet with solder.
(Except the edge of the terminal.)
No damage or cutting off.
No obstacle will be harmful to
normal operation; damage,
cracks, rust, and distortions.
Should not be audible at 1.55 V
sine wave between Fo ~ 20 KHz.
The speaker will be measured
after being placed at +25°C for 6
hours. No obstacle will be harm
ful to normal operation; damage,
cracks, rust, and distortions.
Should not be audible at 1.55 V
sine wave between Fo ~ 20 KHz.
The SPL should be within ±3dB
when compared to the initial
measurements.
Tualatin, OR 97062
Date: 12/06/2006
Unit: mm
Page No: 4 of 5