II-EVB-630W-3-US-110 Connect One, II-EVB-630W-3-US-110 Datasheet - Page 27

• Manufacturer Part Number: II-EVB-630W-3-US-110
• Description: Ethernet Modules & Development Tools iChipSec CO2128 Eval Board -US
• Manufacturer: Connect One
• Type: Evaluation Boardsr

Specifications of II-EVB-630W-3-US-110

• Interface Type: RS-232, Ethernet, USB
• Operating Voltage: 110 V
• Product: Modules
• For Use With/related Products: CO2128SEC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

II-EVB-630W User Manual
2.10
Getting Started


3
4
Configuring for Connection
To connect on the LAN side, the II-EVB-630W needs basic LAN settings, such as IP
Address, Subnet, and Gateway IP address. There are two ways to configure this set
of parameters:
Dynamic IP Allocation (Via DHCP).
Fixed IP Configuration (Via User Assignment).
If the II-EVB-630W is not located, the Serial Settings dialog box is displayed:
This dialog box is also displayed if you select Serial Ports from the menu bar.
From the Serial Port drop-down list, select the PC COM port to which the
II-EVB-630W is connected.
In the Baud Rate area:


If Scan is selected, the iChipConfig Utility runs through the various baud rates
until the correct baud rate is found. The following message is displayed:
Note: If the iChipConfig Utility still fails to find the II-EVB-630W, make sure that
there is no open application, such as Palm HotSync, occupying the port. Switch
to a different COM port and try Scan again. After iChipConfig has found the baud
rate, you can easily change it using the Serial Settings dialog box.
-or-
Select the exact Baud Rate used by the II-EVB-630W.
Select Scan if you don’t know the baud rate.
Getting Started
27