EVALST7590-1 STMicroelectronics, EVALST7590-1 Datasheet - Page 15

• Manufacturer Part Number: EVALST7590-1
• Description: Power Management Modules & Development Tools ST7590 PRIME BRD Narrow-Band OFDM
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of EVALST7590-1

• Interface Type: Ethernet
• Product: Power Management Development Tools
• For Use With/related Products: ST7590
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UM0896
5.10
5.11
USB-OTG configuration
The STM32 microcontroller can distinguish between the host and device mode of the
connected USB circuit by reading ID pin. It is possible to disconnect ID pin from USB
connector CN4 (see
Table 13.
MicroSD Card
The microSD Card connector connected to the SPI1 interface of the STM32 microcontroller
is available on the board. MicroSD Card detection is done through PA4 GPIO signal when
the card is inserted.
Figure 6.
Jumper
R32
USB-OTG configuration
SD Card formats
Table
When 0 Ω resistor is assembled in this position, the
ID signal of the STM32 microcontroller and the ID
signal of the connector CN4 are interconnected.
Otherwise there are disconnected.
(Default - assembled)
13).
Doc ID 17009 Rev 1
Description
Configuration
Configuration
15/43