SUPERPRO-5004GP Xeltek, SUPERPRO-5004GP Datasheet - Page 68
![Programmers & Debuggers ULTRA-HIGH-SPEED 4 SOCKET GANG PROG](/photos/15/96/159605/5004gp_sml.jpg)
SUPERPRO-5004GP
Manufacturer Part Number
SUPERPRO-5004GP
Description
Programmers & Debuggers ULTRA-HIGH-SPEED 4 SOCKET GANG PROG
Manufacturer
Xeltek
Datasheet
1.SUPERPRO5004EGP.pdf
(73 pages)
Specifications of SUPERPRO-5004GP
Positions/sockets
4
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
Common ICs
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
• Programmer not found: The programmer is not connected to the PC or it is
• Programmer not ready: Turn off the programmer power switch and turn it on
• Programmer is running: The programmer hardware is operating. Wait until
• File open error: The open file operation failed.
• Out of Memory: The memory overflows.
• Production mode isnʹt available for this chip: Since the production mode is
• Cancel production mode: Cancel the production mode.
• Too long file name: The file name is too long.
• User cancel: The system displays this message after you select Cancel on the
• Canʹt cancel!: The Cancel operation has failed.
• Not a project file: The file selected is not a project file. After the software is
Insertion Test Errors
The following error messages may occur during the Insertion Test.
• No device in the socket.: The system did not detect a device in the socket.
• Find non‐connection or poor pin contact: The system detected poor pin
• Device inserted backwards or damaged.: Take the chip out, reverse it, and
Superpro
ceased.
connected improperly. Check the connection. Refer to Chapter 2 System
Installation on page 11 for more information.
again after a few seconds.
the operation is finished.
dependent on the pin check, the chips without pin check function are not
applicable for production mode.
Status bar.
updated, the software may not be able to identify a previously created file. You
will need to create the file again.
Insert a chip.
contact. Check the pin contact. If you find nothing wrong with the connection
of the noted pin(s) replace the chip with another in case the first chip is broken.
The pin number refers to DIP chip’s pin number or the adapter’s pin number.
insert it again properly. If the problem still exists, the chip may have been
damaged.
®
5004GP User’s Guide
68