II-EVB-363ML-220 Connect One, II-EVB-363ML-220 Datasheet - Page 7
![WiFi / 802.11 Modules & Development Tools Nano LANReach Evaluation Board](/photos/15/98/159871/evb363_sml.jpg)
II-EVB-363ML-220
Manufacturer Part Number
II-EVB-363ML-220
Description
WiFi / 802.11 Modules & Development Tools Nano LANReach Evaluation Board
Manufacturer
Connect One
Datasheet
1.II-EVB-363MW-US-110.pdf
(27 pages)
Specifications of II-EVB-363ML-220
Interface Type
RS-232, USB
Security
64/128 bit WEP, AES-CCM, TKIP, WPA, WPA2
Operating Voltage
9 VDC
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Connect One
opening a socket. You may also try to PING the iChip from another station on the
network.
7.
The Nano modules support two additional connections:
SPI Slave
The Nano modules support an alternative Host interface to the RS232 Serial port and
the USB connection. A host equipped with an SPI Master connection may connect to
the Nano module’s SPI Slave port and interact with the module with AT+i commands.
An SPI cable (not supplied) connects to the II-EVB-363 J3 SIP connector:
A full description of interfacing the Nano modules with SPI is included below in
Appendix 5.
RJ45 10/100BaseT Ethernet LAN (for Nano WiReach)
The II-EVB-363 contains a standard 10/100BaseT RJ45 connector that allows a direct
connection to a wired LAN. The use for this connection is to implement a WiFi to
LAN bridge with the Nano WiReach module. The bridge feature is supported in Nano
WiReach firmware version 8.04 or later.
II-EVB-363NW User’s Manual
Additional Connections
nSPI_INT
nSPI MOSI
nSPI_CS
nSPI MISO
nSPI_CLK
GND
J3
7