II-EVB-363MS-110 Connect One, II-EVB-363MS-110 Datasheet - Page 25
![WiFi / 802.11 Modules & Development Tools Nano SocketLAN Evaluation Board](/photos/15/98/159871/evb363_sml.jpg)
II-EVB-363MS-110
Manufacturer Part Number
II-EVB-363MS-110
Description
WiFi / 802.11 Modules & Development Tools Nano SocketLAN Evaluation Board
Manufacturer
Connect One
Datasheet
1.II-EVB-363MW-US-110.pdf
(27 pages)
Specifications of II-EVB-363MS-110
Interface Type
RS-232, USB
Security
64/128 bit WEP, AES-CCM, TKIP, WPA, WPA2
Operating Voltage
9 VDC
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Connect One
When AT+i WLTR is issued, transmission rate is limited for the duration of the
session until another AT+iWLTR command is issued, or iChip is power-cycled.
Placement and Range Guidelines
802.11b/g wireless LAN devices connect to wireless LAN Access Points over a
maximum range of 300 feet. Actual transmission rate and service quality may vary
significantly as a result of environmental obstacles and physical placement of the
Access Point and station devices.
For best results, refer to the following guidelines:
Wireless LAN Data Privacy/Security Considerations
The fact that wireless LAN devices transmit data over a radio link makes them
vulnerable to electronic eavesdropping, tampering, and information theft. There are
several means by which you may strengthen your wireless LAN access security:
For a complete Wireless LAN Configuration Guide for iChip products download the
“WiFi Configuration Guide” form the Connect One Web site at:
http://www.connectone.com/support.asp?did=42.
II-EVB-363NW User’s Manual
1. Locate the wireless LAN equipment away from sources of interference, such
2. Position the wireless LAN access point at an elevated position and as close as
• Change the factory default SSID setting of the wireless LAN Access Point and
• Restrict 802.11b/g wireless LAN access based on MAC address. This is
• Place the 802.11b/g Wireless Access Point in a location where it cannot be
• Store printed SSID and WEP or WPA key settings in a safe place.
as PCs, large metal surfaces, microwaves, and cordless phones
possible to the center of the area in which the wireless LAN devices will
operate.
station devices. Enable WEP or WPA encryption of the wireless LAN data
communications. If you use WEP, it is recommended that you use 128-bit
WEP keys.
configurable in most Access Point devices.
physically tampered with.
.
25