USB3290-FH-TR SMSC, USB3290-FH-TR Datasheet - Page 11

• Manufacturer Part Number: USB3290-FH-TR
• Description: Telecom Line Management ICs USB 2.0 PHY UTMI
• Manufacturer: SMSC

Specifications of USB3290-FH-TR

• Product: PHY
• Data Rate: 480 Mbps
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Number Of Channels: 1
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Small Footprint Hi-Speed USB 2.0 Device PHY with UTMI Interface
Datasheet
SMSC USB3290
VDDA1.8
REG_EN
VDD3.3
VDD1.8
(V18A)
NAME
(GND)
(REN)
(V33)
(V18)
(VIO)
VSS
DIRECTION
Input
N/A
N/A
N/A
N/A
ACTIVE
Table 4.5 Power and Ground Signals
LEVEL
High
N/A
N/A
N/A
N/A
DATASHEET
3.3V Supply. Provides power for USB 2.0 Transceiver, UTMI+
Digital, Digital I/O, and Regulators.
On-Chip 1.8V regulator enable. Connect to ground to disable
both of the on chip (VDDA1.8 and VDD1.8) regulators. When
regulators are disabled:
1.8V Digital Supply. Supplied by On-Chip Regulator when
REG_EN is active. Low ESR 4.7uF minimum capacitor
requirement when using internal regulators. Do not connect
VDD1.8 to VDDA1.8 when using internal regulators. When the
regulators are disabled, VDD1.8 may be connected to VDD1.8A.
Common Ground.
1.8V Analog Supply. Supplied by On-Chip Regulator when
REG_EN is active. Low ESR 4.7uF minimum capacitor
requirement when using internal regulators. Do not connect
VDD1.8A to VDD1.8 when using internal regulators. When the
regulators are disabled, VDD1.8A may be connected to VDD1.8.
External 1.8V must be supplied to VDDA1.8 and VDD1.8 pins.
When the regulators are disabled, VDDA1.8 may be connected
to VDD1.8 and a bypass capacitor (0.1 μ F recommended)
should be connected to each pin.
The voltage at VDD3.3 must be at least 2.64V (0.8 * 3.3V)
before voltage is applied to VDDA1.8 and VDD1.8.
11
DESCRIPTION
Revision 1.5 (11-02-07)