AP-CF016GA5GS-NR Apacer, AP-CF016GA5GS-NR Datasheet - Page 35

• Manufacturer Part Number: AP-CF016GA5GS-NR
• Description: Memory Modules CF4 16GB
• Manufacturer: Apacer

Specifications of AP-CF016GA5GS-NR

• Product: Flash
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Memory Size: 16 GB
• Memory Type: Compact Flash Controller
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

This command enables the Device to perform Read and Write Multiple operations and establishes the
block count for these commands. The Sector Count register is loaded with the number of sectors per
block. Upon receipt of the command, the Device sets BSY to 1 and checks the Sector Count register.
If the Sector Count register contains a valid value and the block count is supported, the value is loaded
for all subsequent Read-Multiple and Write-Multiple commands and execution of those commands is
enabled. If a block count is not supported, an Aborted command error is posted, and Read- Multiple and
Write- Multiple commands are disabled. If the Sector Count registers contains 0 when the command is
issued, Read and Write- Multiple commands are disabled. At power-on, or after a hardware or (unless
disabled by a Set-Feature command) software reset, the default mode is Read and Write-Multiple
disabled.
6.1.32 Sleep – E6H or 99H
This command causes the Device to set BSY, enter the Sleep mode, clear BSY and generate an interrupt.
Recovery from sleep mode is accomplished by simply issuing another command (a reset is permitted but
not required). Sleep mode is also entered when internal timers expire so the host does not need to issue
this command except when it wishes to enter Sleep mode immediately. The default value for the timer is
15 milliseconds.
6.1.33 SMART – B0H
The feature register will indicate the subcommand as listed below.

Command Purpose:
This Command is used to communicate the reliability status of the device to the host at the host’s request.
If the device has not detected a threshold exceeded condition, the device sets the LBA Mid register to
4FH and the LBA High register to C2H. If the device has detected a threshold exceeded condition, the
device sets the LBA Mid register to F4H and the LBA High register to 2CH. In the current implementation,
the only threshold checked is that a fatal error has occurred.
© 2009 Apacer Technology Inc.
6.1.33.1 SMART Return Status – DAH
Command (7)
Command (7)
Sec Num (3)
Sec Num (3)
Cyl High (5)
Cyl High (5)
Cyl Low (4)
Cyl Low (4)
Sec Cnt (2)
Sec Cnt (2)
Feature (1)
Feature (1)
C/D/H (6)
C/D/H (6)
Bit ->
Bit ->
7
7
Compact Flash 4 series
AP-CFxxxxA5XS-XXXXXX
6
6
X
X
5
5
34
Drive
Drive
4
4
E6H or 99H
DAH
B0H
C2H
4FH
X
X
X
X
X
X
X
3
3
2
2
X
X
1
1
Rev. 1.0
0
0