LIS3DH STMicroelectronics, LIS3DH Datasheet - Page 17
LIS3DH
Manufacturer Part Number
LIS3DH
Description
Board Mount Accelerometers MEMS Ultra Low-Power 3-Axes Nano
Manufacturer
STMicroelectronics
Datasheet
1.LIS3DH.pdf
(42 pages)
Specifications of LIS3DH
Sensing Axis
X, Y, Z
Acceleration
16 g
Digital Output - Number Of Bits
16 bit
Supply Voltage (max)
3.6 V
Supply Voltage (min)
1.71 V
Supply Current
6 uA to 11 uA
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 40 C
Digital Output - Bus Interface
I2C, SPI
Mounting Style
SMD/SMT
Shutdown
Yes
Sensitivity
1 mg/digit to 12 mg/digit
Package / Case
LGA-16
Output Type
Digital
Acceleration Range
± 2g, ± 4g, ± 8g, ± 16g
No. Of Axes
3
Interface Type
I2C, SPI
Sensitivity Per Axis
12mg / Digit
Sensor Case Style
LGA
No. Of Pins
16
Supply Voltage Range
1.71V To 3.6V
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LIS3DH
Manufacturer:
STMicroelectronics
Quantity:
14 400
Part Number:
LIS3DH
Manufacturer:
ST
Quantity:
20 000
Part Number:
LIS3DHTR
Manufacturer:
ST
Quantity:
20 000
LIS3DH
3.5
3.6
3.7
Factory calibration
The IC interface is factory calibrated for sensitivity (So) and Zero-g level (TyOff).
The trimming values are stored inside the device in a non volatile memory. Any time the
device is turned on, the trimming parameters are downloaded into the registers to be used
during the active operation. This allows to use the device without further calibration.
FIFO
The LIS3DH contains a 10 bit, 32-level FIFO. Buffered output allows 4 operation modes:
FIFO, stream, trigger and FIFO ByPass. Where FIFO bypass mode is activated FIFO is not
operating and remains empty. In FIFO mode, data from acceleration detection on x, y, and z-
axes measurements are stored in FIFO.
Auxiliary ADC
The LIS3DH contains an auxiliary 10 bit ADC with 3 separate dedicated inputs.
Doc ID 17530 Rev 1
Terminology and functionality
17/42