SV01A103AEA01B00 Murata, SV01A103AEA01B00 Datasheet - Page 18

• Manufacturer Part Number: SV01A103AEA01B00
• Description: Board Mount Motion & Position Sensors 10K OHM SMD
• Manufacturer: Murata

Specifications of SV01A103AEA01B00

• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
3. Ensure that the connection impedance is at least 1M .
4. When using the product in an atmosphere containing a corrosive gas (chlorine, sulfur, etc.), install it in a sealed structure.
5. Ensure that the positions of the mechanical part (shaft) that you wish to connect to the product and the product rotor hole do not become misaligned.
16
This product has increased contact resistance (sliding noise)
in order to maximize its rotational life. Consequently, in order
to reduce the effect of sliding noise, it is necessary to reduce
the current flowing through the contacts (current i indicated in
the figure at right) as far as possible. Accordingly, take steps
to ensure that the internal impedance of the circuit connected
to the output terminal (#2 terminal) is at least 1M .
Be particularly careful in the case of the filter circuit shown in
the figure at right.
The graph at right shows the results of measuring the output
voltage linearity of the same sample when the impedance to
which it is connected is changed between 1M and 200k . It
can be seen that the effect of sliding noise is reduced when
the connection impedance is increased.
This product is not of a sealed construction, so the contacts and resistive element inside it are exposed directly to the ambient air.
For this reason, if the product is used in an atmosphere containing a corrosive gas, the contacts and resistive element may corrode.
When it is unavoidably necessary to use the product in an atmosphere containing a corrosive gas, install the product in a sealed
structure.
When combining a mechanical part with the product, ensure that the center of the product rotor hole coincides with the center of the
shaft to be inserted into the rotor. If you use these parts in a misaligned condition, the bearing may wear, resulting in the following
trouble.
Continued from the preceding page.
q Deterioration of output voltage linearity due to play in the rotor
w Deterioration of the contact condition of the contacts due to wear dust
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
SV01 Series Application Manual
Product
Graph 2 When the connection impedance is 200k
3.9
3.8
3.7
3.6
3.5
3.4
3.3
4.2
4.1
4.0
3.9
3.8
3.7
3.6
Graph 1 When the connection impedance is 1M
630
630
640
640
650
650
i
660
660
670
670
680
680
690
690
A/D
700
700
R51E.pdf
09.3.26