SC24M62TK6 Souriau Connection Technology, SC24M62TK6 Datasheet - Page 78

• Manufacturer Part Number: SC24M62TK6
• Description: CONTACT SOCKET 26-24AWG TIN
• Manufacturer: Souriau Connection Technology
• Series: Trim Trio® SM/SC-Mr
• Type: Stampedr

Specifications of SC24M62TK6

• Pin Or Socket: Socket
• Size: 16
• Wire Gauge: 24-26 AWG
• Contact Termination: Crimp
• Contact Finish: Tin
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Contact Finish Thickness: -
• Other names: Q4702008; T0968173

Crimping instructions
The conductor and insulation crimp
section
Are designed to accommodate wire-
conductor and insulation diameters,
expressed in AWG (American Wire Gauge)
or mm
For each wire gauge, a correct crimp
requires a crimp height that offers the
highest performance.
This performance is defined as the highest
tensile strength force.
A good conductor crimp can be guaranteed
if the tensile stength force is equal or higher
as indicated on the graph below. E.g. a
conductor of AWG20 (0.52 mm
good crimp if the tensile strength is min
84N.
2
.
2
) has a
The tensile strength force is measured in
Newtons and is the wire-to-contact
connection that will withstand when a
straight axial load is applied to the
terminated wire. This is however a
destructive test and is therefore
inappropriate as a 100% inspection
method.
An alternative method is to measure crimp
height. The crimp height is measured at the
conductor-crimp section.
• If the dimension is too small, then the
conductor is over-crimped and the wire
strands could be damaged, which results
in a lower tensile strength force.
Contacts
80
• If the dimension is too large, then the
In both cases, the application tooling’s
crimp height should be adjusted.
In order to have the right tooling’s crimp
height go and no-go gauges can be
obtained and are defined in function of the
type of crimp tooling and the wire gauge.
For further information consult factory.
conductor is under-crimped and the wire
strands will not be deformed enough to
assure that the crimp will pass the tensile
strength test.