MIL-22520/7/01 Souriau Connection Technology, MIL-22520/7/01 Datasheet - Page 18

• Manufacturer Part Number: MIL-22520/7/01
• Description: Circular MIL / Spec Connectors CRIMP TOOL FRAME
• Manufacturer: Souriau Connection Technology
• Series: JBX Seriesr
• Type: Crimping Toolr

Specifications of MIL-22520/7/01

• Product Type: Tools
• Termination Style: Crimp
• Cable Diameter: 0.7 mm to 0.9 mm, 1.3 mm
• Product: Crimping, Stripping & Cutting Tools & Drills
• Description/function: Contact Crimping
• Wire Gauge Range: 28-16
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: Contacts 0.7 mm to 9 mm, 1.3 mm

JBX Series
Push-Pull Connectors
Wiring & assembly instructions
Straight plug
Cable stripping :
Connector preparation
Contact wiring : crimp contacts
Contact wiring : solder contacts
Connector assembly
Fixed solder contacts 0.5 mm and 0.7 mm
1 - Terminate the bucket contacts
using solder method
see page 21 7
18
engage them into the insert cavities
1 - Solder the conductors to the contact buckets then
Removable solder contacts from 0.9 mm to 2 mm
1 - Select the proper collet . (see page 21 7)
2 - Slide the protective boot  the backnut
3 - In case of a screened cable, combs out
1 - Select the proper crimping tool (see page
2 - Adjust the tool selector for the correspon-
3 - Crimp the contacts  and then engage
1 - Position 2 half bushes  on the insert
2 - Position the collet and the half bushes
3 - Position all the sub-assembly in the
4 - Install the backnut  and screw it. Use the
5 - Install the protective boot  if exists.
 and the collet  onto the cable.
the screen and fold back over the collet
.
48) and locator according to the connectors
involved.
ding conductor AWG.
them into the insert cavities  till clip
tightening.
making sure that the insert key appears
through window of one bush.
while maintaining the screen. Bush keys
are seated in the collet keying slots.
connector housing  making sure to keep
sub-assembly aligned.
two wrenches well positionned on the flats
A and B. Place a wrench to grip flats B, use
the other wrench to tighten the backnut at
the flats A following the torque values on
page 21 7.

till clip holding