FGN.3F.330.XLCS LEMO, FGN.3F.330.XLCS Datasheet - Page 43

• Manufacturer Part Number: FGN.3F.330.XLCS
• Description: Circular Push Pull Connectors 30P STRAIGHT PLUG MALE CRIMP W/COLLET
• Manufacturer: LEMO
• Series: F Seriesr

Specifications of FGN.3F.330.XLCS

• Product Type: Connectors
• Contact Style: Pin (Male)
• Shell Style: Plug
• Number Of Contacts: 30
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Assembly instructions for plugs and sockets
www.lemo.com
3
3
2
2
L
S
T
± 0.5
± 0.5
± 0.2
PEN
FGN
PHN
Crimp
Crimp
Heat
Tie wrap
Tie wrap
1
3
3
3
Assembly instructions
Heat
2
2
1.
2.
2.1 With shielded cables, widen and pull the shield all the way to the back.
2.2 Arrange the conductor-contact assemblies according to the mar-
2.3 Bring the shield around the rear of connector. Secure it with a band-it
2.4 Put the heatshrink boot in place and heat gently until it retracts.
Cable preparation
First place the heatshrink boot
over the cable. Strip the cable accor -
ding to dimensions of the table, then
widen the shield.
Cable termination
Fix the appropriate positioner onto the crimping tool and set the selec-
tor to the number corresponding to the AWG of the conductor used as
indicated on the positioner label. Fit the conductor into the contact ➁;
make sure it is visible through the contact’s inspection hole.
Slide the conductor-contact assembly into the open crimping tool;
make sure that the contact is pushed fully into the positioner.
Close the tool.
Remove from crimping tool and check that conductor is secure in
contact and shows in inspection hole.
kings, into the rear cable seal. Push them deeply into the insulator,
using tweezers if necessary; check that all the contacts are correctly
located in the insulator: 1) by verifying the alignment of the contacts
at the front of the insulator and 2) by gently pulling on each conduc-
tor. Verification should also be made using the appropriate retention
testing tool.
With FF series the rear cable seal can be replaced with a silicone
RTV compound that is filled on the rear of the connector once the
contacts are correctly installed.
tie-wrap (not furnished) to fix the shield in place.
Cut off the possible shield surplus.
1
1
➀
Series
0F-5F
FF
14
20
®
L
15
S
9
T
3
4
41
®