LPY430AL STMicroelectronics, LPY430AL Datasheet - Page 10

• Manufacturer Part Number: LPY430AL
• Description: Gyroscopes MEMS Motion Sensor 300 Dps Gyro
• Manufacturer: STMicroelectronics

Specifications of LPY430AL

• Sensing Axis: Dual
• Supply Current: 6.8 mA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.7 V
• Sensitivity: 0.83 mV/deg/s
• Package / Case: LGA-28
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Application hints
5
10/14
Application hints
Figure 3.
Power supply decoupling capacitors (100 nF ceramic or polyester + 10 µF aluminum) should
be placed as near as possible to the device (common design practice).
The LPY430AL allows band limiting of the output rate response through the use of an
external low-pass filter (recommended) in addition to the embedded low-pass filter (f
Hz).
The 4xOUTX and 4xOUTZ are, respectively, OUTX and OUTZ amplified output lines,
internally buffered to ensure low output impedance.
If external low-pass filtering is not applied, it is mandatory to short-circuit pin 1 to pin 5 and
pin 16 to pin 20, respectively, when amplified outputs are used.
When only a non-amplified output is used (OUTX/OUTZ), it is recommended to set pin 5
and 16 to a fixed reference voltage (Vref).
The LPY430AL IC includes a PLL (phase-locked loop) circuit to synchronize driving and
sensing interfaces. Capacitors and resistors must be added at the FILTVDD and VCONT
pins (as shown in
LPY430AL electrical connections and external components values
Figure
3) to implement a low-pass filter.
Doc ID 16579 Rev 1
LPY430AL
t
= 140