E2EV-X5C1 Omron, E2EV-X5C1 Datasheet - Page 5

• Manufacturer Part Number: E2EV-X5C1
• Description: Proximity Sensors M18 NPN-NO out 5mm All metal inductive
• Manufacturer: Omron
• Type: All Metal Sensing Inductive Proximity Sensorr
• Series: E2EVr

Specifications of E2EV-X5C1

• Maximum Operating Temperature: + 55 C
• Supply Voltage: 30 V
• Operating Supply Voltage: 10 V to 30 V
• Minimum Operating Temperature: - 10 C
• Maximum Output Current: 100 mA
• Barrel Size: M18
• Features: One sensor detects all kinds of metal at equal distance
• Sensing Distance: 5 mm
• Sensor Input: Inductive
• Sensing Range: 5mm
• Supply Voltage Range Dc: 12V To 24V
• Switch Terminals: Cable
• Supply Voltage Min: 10VDC
• Sensor Output: NPN, NO
• Sensor Housing: Cylindrical
• Leaded Process Compatible: No
• Output Type: NPN, NO
• Peak Reflow Compatible (260 C): No
• Sensing Range Max: 5mm
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant, Lead free / RoHS Compliant

Safety Precautions
Refer to Warranty and Limitations of Liability.
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Do not use this product under ambient conditions that exceed the
ratings.
● Design
Influence of Surrounding Metal
When mounting the Sensor within a metal panel, ensure that the
clearances given in the following table are maintained. Failure to
maintain these distances may cause deterioration in the performance
of the Sensor.
Influence of Surrounding Metal
Mutual Interference
When installing Sensors face-to-face or side-by-side, ensure that the
minimum distances given in the following table are maintained.
Mutual Interference
Model
E2EV-X2C@
E2EV-X5C@
E2EV-X10C@
Model
E2EV-X2C@
E2EV-X5C@
E2EV-X10C@
l
m
Precautions for Correct Use
Item
Item
100
30
50
A
(Unit: mm)
0
l
WARNING
20
35
70
B
D
12
18
30
d
d dia.
(Unit: mm)
D
0
20
40
m
B
8
A
l
m
n
18
27
45
n
● Mounting
Do not tighten the nut with excessive force. A toothed washer must be
used with the nut.
Note: 1. The allowable tightening strength depends on the distance from the
Model
E2EV-X2C@
E2EV-X5C@
E2EV-X10C@
Tightening Torque
2. The following strength assume washers are being used.
edge of the head, as shown in the following table. (A is the distance
from the edge of the head. B includes the nut on the head side. If the
edge of the nut is in part A, the tightening torque for part A applies
instead.)
Dimension
(mm)
17
22
26
Part A
5.9 N·m
Torque
15 N·m
39 N·m
Part B Part A
E2EV
9.8 N·m
Torque
49 N·m
78 N·m
Part B
5