E2E-X1R5F1 Omron, E2E-X1R5F1 Datasheet - Page 13

• Manufacturer Part Number: E2E-X1R5F1
• Description: Proximity Sensors PROXIMITY SENSOR
• Manufacturer: Omron
• Series: E2Er

Specifications of E2E-X1R5F1

• Maximum Operating Temperature: + 85 C
• Supply Voltage: 30 V
• Output Voltage: 2 V
• Operating Supply Voltage: 12 V to 24 V
• Minimum Operating Temperature: - 40 C
• Maximum Output Current: 200 mA
• Features: High visibility indicator
• Sensing Distance: 1.5 mm
• Sensor Housing: Cylindrical
• Sensor Input: Inductive
• Sensing Range Max: 1.5mm
• Switch Terminals: Cable
• Sensor Output: PNP-NO
• Proximity Sensor Type: Inductive
• Output Type: PNP
• Proximity Sensor Sensing Distance: 1.5mm
• Proximity Sensor Sensing Distance Range: <2mm
• Proximity Sensor Switching Mode: NO
• Mounting: Panel
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 10V
• Operating Supply Voltage (typ): 12/15/18/24V
• Operating Supply Voltage (max): 40V
• Pin Count: 3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

E2E 3-Wire DC
Installation
J MOUNTING
Do not tighten the nut with excessive force. A washer must be used
with the nut.
Note:
Shielded Model
Connector
M8 Nano
ChangeR
The table above right shows the tightening torques for part
A and part B nuts. In the previous examples, the nut is on
the sensor head side (part B) and hence the tightening
torque for part B applies. If this nut is in part A, the tightening
torque for part A applies instead.
Part B Part A
Output configuration
NO
NC
Unshielded Model
Applicable models
E2E-XjE1-M3
E2E-XjF1- M3
E2E-XjE2-M3
E2E-XjF2- M3
Part B Part A
Pin arrangement
Refer to the following to mount the E2E-CR8 and E2E-C1 non-
screw models.
Tighten the screw to a torque of 0.20 N S m (2 kgf S cm) maximum to
secure the E2E-CR8 and a torque of 0.39 N S m (4 kgf S cm) maxi-
mum to secure the E2E-C1.
Type
M5
M8
M12
M18
M30
14
yp
Shielded
Unshielded
Load
Load
Load
Load
8 to 21 mm
Part A
Length
1 N S m (10 kgf S cm)
9 mm
3 mm
30 N S m (310 kgf S cm)
70 N S m (710 kgf S cm)
180 N S m (1,800 kgf S cm)
M3 hole
No screw is provided with
the E2E-CR8 or E2E-C1.
Note:
Note:
Note:
Note:
Torque
9 N S m
(90 kgf S cm)
Terminal 4 is not used.
Terminal 2 is not used.
Terminal 2 is not used.
Terminal 4 is not used.
E2E 3-Wire DC
Part B
Torque
12 N S m
(120 kgf S cm)