CPMC882 Emerson Network Power, CPMC882 Datasheet - Page 2

• Manufacturer Part Number: CPMC882
• Description: CONN BNC PLUG SOLDER OR CRIMP
• Manufacturer: Emerson Network Power
• Series: BNCr
• Type: Cable Plugr

Specifications of CPMC882

• Connector Style: BNC
• Connector Type: Plug, Male Pins
• Contact Termination: Crimp and Solder
• Impedance: 50 Ohm
• Mounting Type: Free Hanging (In-Line)
• Fastening Type: Bayonet Lock
• Cable Group: RG-59, 62
• Frequency - Max: 4GHz
• Frequency-max: 4GHz
• Angle: Straight
• Application: Commercial
• Cable Type: RG 59,62
• Contact Plating: Gold
• Finish, Housing: Nickel
• Gender: Male
• Material, Contact: Brass, Beryllium Copper or Phosphor Bronze
• Material, Dielectric: Delrin or TPX Polymethylpentene
• Material, Housing: Brass/Zinc
• Mating Type: Bayonet
• Primary Type: BNC
• Special Features: 3-Pc
• Termination: Crimp/Solder
• Voltage, Rating: 500 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Color: -
• Lead Free Status / Rohs Status: RoHS Compliant part
• Other names: 012446237667; 367-0048; 367-0048; 367-1048; CPMC-88-2

Cambridge Products, P.O. Box 1732, Waseca, MN 56093-0832 • 1-800-243.8814 • Fax: [phone] • www.cambridgeproducts.com
BNC 50 Ohm Straight Crimp Type Plug -
Solder or Crimp Contact - 3 Piece
PART NUMBER
CPMC-88-2
Part Number
CPMC-88-2
CABLE TYPE
RG-59, 62
Cable
RG-59
.520 (13.20)
“A”
.315 (8.00)
“A”
.595 (15.11)
Strip Dimensions
“B”
.118 (3.00)
“B”
1. Identify connector parts. (3 piece parts)
2. Strip cable to dimensions shown. Do not nick braid or cen-
3. Assemble contact onto cable as shown.
4. Flare braid and slide body assembly over contact and un-
ter conductor. Tin center conductor if contact will be solder
attached. Do not tin center conductor if contact is to be
crimp attached. A wire stripper of correct size is recom-
mended for this step. Slide heat shrink (as applicable) and
crimp sleeve onto jacket of cable.
Solder Attachment: Solder contact to center conductor
through hole using a minimum amount of solder for a good
joint.
Crimp Attachment (where applicable): Crimp contact to
center conductor using recommended crimp hex.
der braid. Then seat body assembly firmly onto contact.
The cable may have to be held in a clamping fixture. Ar-
range braid uniformly around crimp stem. Slide crimp sleeve
forward and crimp using recommended crimp hex. Slide
heat shrink forward and shrink (as applicable).
CONTACT I.D.
.034 (0.86)
.157 (4.00)
“C”
.255 (6.48)
Sleeve Hex Crimp Hex
Crimp
BODY I.D.
.173 (4.39)
INCHES (MILLIMETERS)
CUSTOMER DRAWINGS AVAILABLE UPON REQUEST
.066 (1.69)
Contact
FERRULE I.D.
.261 (6.63)
Recommended
Crimp Hex
24-305P