SI5100-H-BL Silicon Laboratories Inc, SI5100-H-BL Datasheet - Page 34

• Manufacturer Part Number: SI5100-H-BL
• Description: IC TXRX SONET/SDH LP HS 195-PBGA
• Manufacturer: Silicon Laboratories Inc

Specifications of SI5100-H-BL

• Product: PHY
• Supply Voltage (max): 1.89 V, 3.47 V
• Supply Voltage (min): 1.71 V
• Supply Current: 0.83 A
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 20 C
• Mounting Style: SMD/SMT
• Maximum Power Dissipation: 1600 mW
• Number Of Channels: 1
• Package / Case: BGA-195
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Si5100
34
Pin Number(s)
G5–10, H5–10,
E5–10, F5–10,
J5–10, K5–10
M12
M9
H3
C5
L3
TXMSBSEL
TXSQLCH
TXREXT
Name
V
VREF
V
DDIO
DD
V
V
I/O
DDIO
O
DD
I
I
1.8 V or 3.3 V LVTTL I/O Supply Voltage.
Signal Level
Voltage Ref
LVTTL
LVTTL
Rev. 1.4
1.8 V
Transmit Data Bus Bit Order Select.
This input determines the order in which data
bits received on the TXDIN[15:0] bus are trans-
mitted on the high-speed serial output TXDOUT.
For TXMSBSEL = 0, data on TXDIN0 is trans-
mitted first followed by TXDIN1 through
TXDIN15 (TXDIN1 through TXDOUT3 if
MODE16 = 0).
For TXMSBSEL = 1, TXDIN15 (TXDIN3) is
transmitted first followed by TXDIN14 (TXDIN2)
through TXDIN0.
Note: This input has an internal pulldown.
Transmitter External Bias Resistor.
This resistor is used by the transmitter circuitry
to establish bias currents within the device. This
pin must be connected to GND through a
3.09 k Ω ( 1 %) resistor.
Transmit Data Squelch.
When TXSQLCH is set low, the output data
stream on TXDOUT is forced to a zero state. Set
TXSQLCH high for normal operation.
The TXSQLCH input is ignored when operating
in line loopback mode (LLBK = 0).
Note: This input has an internal pullup.
Supply Voltage.
Nominally 1.8 V.
Connect to either 1.8 or 3.3 V. When connected
to 3.3 V, LVTTL compatible voltage swings are
supported on the LVTTL inputs and LVTTL out-
puts of the device.
Voltage Reference.
The Si5100 provides an output voltage reference
that can be used by an external circuit to set the
LOS threshold, slicing level, or sampling phase
adjustment. The equivalent resistance between
this pin and GND should not be less than 10 k Ω .
The reference voltage is nominally 1.25 V.
Description