HVLED805 STMicroelectronics, HVLED805 Datasheet - Page 16

• Manufacturer Part Number: HVLED805
• Description: IC LED DRVR ACDC OFFLINE 16NSOIC
• Manufacturer: STMicroelectronics

Specifications of HVLED805

• Constant Current: Yes
• Constant Voltage: Yes
• Internal Driver: Yes
• Type - Primary: General Purpose
• Mounting Type: Surface Mount
• Topology: AC DC Offline Switcher, PWM
• Number Of Outputs: 1
• Voltage - Supply: 11.5 V ~ 23 V
• Package / Case: 16-SOIC (0.154", 3.90mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Frequency: -
• Voltage - Output: -
• Operating Temperature: -

Application information
Figure 13. Drain ringing cycle skipping as the load is progressively reduced
Note:
5.4
16/29
V
DS
T
ON
T
osc
T
FW
After the first few cycles initiated by the starter, as the voltage developed across the auxiliary
winding becomes large enough to arm the DMG circuit, MOSFET’s turn-on will start to be
locked to transformer demagnetization, hence setting up QR operation.
The starter is activated also when the IC is in CC regulation and the output voltage is not
high enough to allow the DMG triggering.
If the demagnetization completes – hence a negative-going edge appears on the DMG pin –
after a time exceeding time T
on again, with some delay to ensure minimum voltage at turn-on. If, instead, the negative-
going edge appears before T
going edge after T
cycles will be skipped (“valley-skipping mode”,
be prevented from exceeding 1/T
That when the system operates in valley skipping-mode, uneven switching cycles may be
observed under some line/load conditions, due to the fact that the OFF-time of the MOSFET
is allowed to change with discrete steps of one ringing cycle, while the OFF-time needed for
cycle-by-cycle energy balance may fall in between. Thus one or more longer switching
cycles will be compensated by one or more shorter cycles and vice versa. However, this
mechanism is absolutely normal and there is no appreciable effect on the performance of
the converter or on its output voltage.
Constant voltage operation
The IC is specifically designed to work in primary regulation and the output voltage is
sensed through a voltage partition of the auxiliary winding, just before the auxiliary rectifier
diode.
Figure 14
connections.
T
(limit condition)
V
P
in
= P
in'
shows the internal schematic of the constant voltage mode and the external
BLANK
t
V
DS
will turn-on the MOSFET. In this way one or more drain ringing
BLANK
BLANK
T
Doc ID 18077 Rev 1
osc
BLANK
P
in
has elapsed, it will be ignored and only the first negative-
from the previous turn-on, the MOSFET will be turned
= P
in''
.
< P
in'
Figure
13) and the switching frequency will
t
V
DS
T
osc
P
in
= P
in'''
< P
in''
HVLED805
t