NCP3101CMNTXG ON Semiconductor, NCP3101CMNTXG Datasheet - Page 22

• Manufacturer Part Number: NCP3101CMNTXG
• Description: IC CONV PWM REG BUCK 6A 40-QFN
• Manufacturer: ON Semiconductor
• Type: Step-Down (Buck)r

Specifications of NCP3101CMNTXG

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 1
• Voltage - Output: Adj to 0.8V
• Current - Output: 6A
• Frequency - Switching: 275kHz
• Voltage - Input: 4.5 V ~ 13.2 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 40-VFQFN Exposed Pad
• Output Voltage: 800 mV
• Input Voltage: 5 V to 12 V
• Switching Frequency: 275 KHz
• Operating Temperature Range: - 40 C to + 125 C
• Mounting Style: SMD/SMT
• Duty Cycle (max): 82 %
• Isolated/non-isolated: Non Isolated
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

current during max load, then an input fuse should be rated
accordingly using I
If the inrush current is higher than the steady state input
Figure 35. Voltage Enable Load Current
Voltage
Output
Current
Output
2
t methodology.
1.0V
tss
t
3.3V
http://onsemi.com
22
Layout Considerations
layout is very important. Using a good layout can solve
many problems associated with these types of power
supplies as transients occur.
for converter stability. They should be placed close to the
NCP3101C. The feedback trace is recommended to be kept
as far from the inductor and noisy power traces as possible.
The resistor divider and feedback acceleration circuit (R2,
R3, R6, C13) are recommended to be placed near output
feedback (Pin 16, NCP3101C).
generate voltage transients across the impedances of the
interconnecting bond wires and circuit traces. The
interconnecting impedances should be minimized by using
wide, short printed circuit traces. The critical components
should be located together as close as possible using ground
plane construction or single point grounding. The inductor
and output capacitors should be located together as close as
possible to the NCP3101C.
When designing a high frequency switching converter,
External compensation components (R1, C9) are needed
Switching current from one power device to another can