STM32W108B-SK STMicroelectronics, STM32W108B-SK Datasheet
STM32W108B-SK
Specifications of STM32W108B-SK
Available stocks
Related parts for STM32W108B-SK
STM32W108B-SK Summary of contents
Page 1
Introduction This application note describes a method which could be used to characterize adjacent channel rejection (ACR chips. It also compares different methods used by other manufacturers when quoting ACR performance. Adjacent channel rejection (ACR ...
Page 2
Interferer waveforms Table 1. Minimum receiver jamming resistance requirements for 2450 MHz PHY Adjacent channel rejection The adjacent channel rejection shall be measured as follows. The desired signal shall be a compliant 2450MHz IEEE 802.15.4 signal of pseudo-random data. The ...
Page 3
AN3218 Figure 1. Comparison of spectra, 25 MHz span It can be seen that the heavily filtered 15.4 signal generated by the signal generator is not representative of either type of modulation technique, and therefore does not give a useful ...
Page 4
Co-channel measurements Figure 2. Comparison of spectra, 10 MHz span 4 Co-channel measurements It should also be noted that co-channel interference measurements should be made using a properly modulated IEEE 802.15.4-2003 signal, and not with an MSK signal with random ...
Page 5
... The use of a filtered 15.4 signal is not representative of a real world scenario, and is not well enough specified to ensure consistency between manufacturers. After reading this document If you have questions or require assistance with the procedures described in this document, contact STMicroelectronics support at www.st.com/stm32w. 6 Revision history Table 2. ...
Page 6
... Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. ...