TS19371CX6 RF Taiwan Semiconductor, TS19371CX6 RF Datasheet - Page 6

• Manufacturer Part Number: TS19371CX6 RF
• Description: LED DRIVER, WHITE, BOOST, 6SOT26
• Manufacturer: Taiwan Semiconductor

Specifications of TS19371CX6 RF

• Led Driver Application: Backlighting, Display Module
• No. Of Outputs: 1
• Output Current: 650mA
• Output Voltage: 36V
• Input Voltage: 2.5V To 18V
• Dimming Control Type: PWM
• Operating: RoHS Compliant
• Topology: Boost
• Operating Temperature Range: -40°C To +85°C
• Switching Frequency: 1.2MHz
• Efficiency: 89%
• Rohs Compliant: Yes

Application Information (Continue)
LED Dimming Control
There are some different types of dimming control circuits:
1. Using a PWM Signal to SHDN Pin
With the PWM signal applied to the SHDN pin, the TS19371 is turned on or off by the PWM signal. The LEDs operate
at either zero or full current. The average LED current increases proportionally with the duty cycle of the PWM signal. A
0% duty cycle will turn off the TS19371 and corresponds to zero LED current. A 100% duty cycle corresponds to full
current. The typical frequency range of the PWM signal is 1kHz to 10kHz.
The magnitude of the PWM signal should be higher than the minimum SHDN voltage high.
For some applications, the preferred method of brightness control is a variable DC voltage to adjust the LED current.
The dimming control using a DC voltage is shown in below figure. As the DC voltage increases, the voltage drop on R2
increases and the voltage drop on R1 decreases. Thus, the LED current decreases. The selection of R2 and R3 will
make the current from the variable DC source much smaller than the LED current and much larger than the FB pin bias
current. For VDC range from 0V to 2V, the selection of resistors in Figure 4 gives dimming control of LED current from
0mA to 20mA.
2. Using a Filtered PWM Signal
The filtered PWM signal can be considered as an adjustable DC voltage. It can be used to replace the variable DC
voltage source in dimming control. The circuit is shown as follow:
Dimming Control using a Filtered PWM Signal
Dimming Control using a DC Voltage
Boost (Step-up) WLED Driver with OVP
6/8
VDC(V)
PWM : 2V ; 1KHz ; Vin=3.6V
1.8
1.6
1.4
1.2
0.8
0.6
0.4
0.2
2
1
0
100%
Duty
20%
30%
40%
50%
60%
70%
80%
0%
VFB
19.6
31.1
43.4
86.4
96.9
102
2.2
9.2
63
74
0
Iout ( mA)
Iout(mA)
17.4
12.4
4.07
0.43
12.3
14.5
16.9
6.4
20
15
10
1.8
3.6
8.5
8
0
19
20
0
6
TS19371
Version: F08