AM29F016D-70E4F Spansion Inc., AM29F016D-70E4F Datasheet - Page 20

• Manufacturer Part Number: AM29F016D-70E4F
• Description: IC, FLASH, 16MBIT, 70NS, TSOP-40
• Manufacturer: Spansion Inc.

Specifications of AM29F016D-70E4F

• Memory Type: Flash
• Memory Size: 16Mbit
• Memory Configuration: 2M X 8
• Ic Interface Type: Parallel
• Access Time: 70ns
• Supply Voltage Range: 4.5V To 5.5V
• Memory Case Style: TSOP
• No. Of Pins: 40
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

After an erase-suspended program operation is com-
plete, the system can once again read array data within
non-suspended sectors. The system can determine
the status of the program operation using the DQ7 or
DQ6 status bits, just as in the standard program oper-
ation. See
information.
The system may also write the autoselect command
sequence when the device is in the Erase Suspend
mode. The device allows reading autoselect codes
even at addresses within erasing sectors, since the
codes are not stored in the memory array. When the
device exits the autoselect mode, the device reverts to
the Erase Suspend mode, and is ready for another
valid operation. See
for more information.
The system must write the Erase Resume command
(address bits are “don’t care”) to exit the erase suspend
mode and continue the sector erase operation. Further
writes of the Resume command are ignored. Another
Erase Suspend command can be written after the de-
vice has resumed erasing.
Notes:
1. See the appropriate Command Definitions table for erase command sequence.
2. See
18
“DQ3: Sector Erase Timer”
Figure 3. Erase Operation
“Wr ite Operation Status”
“Autoselect Command Sequence”
for more information.
for more
D A T A
Am29F016D
S H E E T
No
Command Sequence
Erasure Completed
Write Erase
from System
Data = FFh?
Data Poll
START
Yes
21444E9 November 16, 2009
Embedded
Erase
algorithm
in progress