QT60326-ASG QUANTUM ATMEL, QT60326-ASG Datasheet - Page 8

no-image

QT60326-ASG

Manufacturer Part Number
QT60326-ASG
Description
TOUCH SENSOR 32 CHAN, SMD, 60326
Manufacturer
QUANTUM ATMEL
Datasheet

Specifications of QT60326-ASG

Supply Current
25mA
Supply Voltage Range
4.75V To 5.25V
Sensor Case Style
TQFP
No. Of Pins
44
Operating Temperature Range
-40°C To +105°C
Operating Temperature Max
105°C
Operating Temperature
RoHS Compliant
Interface Type
UART, SPI
Rohs Compliant
Yes

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
QT60326-ASG
Manufacturer:
Rohm
Quantity:
4 982
FMEA error flags are cleared. Any FMEA errors will be reported
as the tests are performed for the first time.
The FMEA testing is done on all enabled keys in the matrix, and
results are reported via the serial interface through a dedicated
status command (page 15). Disabled keys are not tested. The
existence of an error is also reported in normal key reporting
commands such as Report 1st Key, page 15.
Assuming no detect events occur, the real time that elapses
from the start of one sequence of FMEA tests to the start of the
next, i.e. the FMEA sequence time, never exceeds 2s.
Also, since the devices only communicate in slave mode, the
host can determine immediately if the QT has suffered a
catastrophic failure. The QT can also participate in
cross-checking the integrity of the host controller, and even
reset the host if no communications have been heard from it in
a short while (via the LED pin output, page 23).
The FMEA tests performed are:
lQ
X drive line shorts to Vdd and Vss
X drive line shorts to other pins
8
Other tests incorporated into the devices include:
For those applications requiring it, Quantum can supply sample
FMEA test data on special request.
X drive signal deviation
Y line shorts to Vdd and Vss
Y line shorts to other pins
X to Y line shorts
Cs capacitor checks including shorts and opens
Vref test
A test for signal levels against a preset min value (LSL
setup, see Section 5.15, page 23). If any signal level falls
below this level, an error flag is generated.
CRC communications checks on all critical command and
data transmissions.
‘Last-command’ command to verify that an instruction was
properly received.
Loss of communications reset of the host controller.
QT60486-AS R8.01/0105

Related parts for QT60326-ASG