LP2980AIM5X-5.0 National Semiconductor, LP2980AIM5X-5.0 Datasheet - Page 5

• Manufacturer Part Number: LP2980AIM5X-5.0
• Description: Voltage Regulator IC
• Manufacturer: National Semiconductor

Specifications of LP2980AIM5X-5.0

• No. Of Pins: 3
• Output Current: 50mA
• Peak Reflow Compatible (260 C): No
• Reel Quantity: 3000
• Output Voltage: 5V
• Termination Type: Through Hole
• Output Voltage Max: 5V
• Supply Voltage Max: 16V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Electrical Characteristics
Note 3: The maximum allowable power dissipation is a function of the maximum junction temperature, T
the ambient temperature, T
The value of
cessive die temperature, and the regulator will go into thermal shutdown.
Note 4: If used in a dual-supply system where the regulator load is returned to a negative supply, the LP2980 output must be diode-clamped to ground.
Note 5: The output PNP structure contains a diode between the V
will turn on this diode (see Application Hints).
Note 6: Limits are 100% production tested at 25˚C. Limits over the operating temperature range are guaranteed through correlation using Statistical Quality Control
(SQC) methods. The limits are used to calculate National’s Average Outgoing Quality Level (AOQL).
Note 7: Dropout voltage is defined as the input to output differential at which the output voltage drops 100 mV below the value measured with a 1V differential.
Note 8: The ON/OFF inputs must be properly driven to prevent misoperation. For details, refer to Application Hints.
Note 9: See Typical Performance Characteristics curves.
Basic Application Circuit
stability margin (see Application Hints).
*
**
***
ON/OFF input must be actively terminated. Tie to V
Minimum Output Capacitance is 1 µF to insure stability over full load current range. More capacitance provides superior dynamic performance and additional
Do not make connections to this pin.
JA
for the SOT-23 package is 220˚C/W and the micro SMD package is 320˚C/W. Exceeding the maximum allowable power dissipation will cause ex-
A
. The maximum allowable power dissipation at any ambient temperature is calculated using:
IN
(Continued)
if this function is not to be used.
IN
and V
OUT
terminals that is normally reverse-biased. Reversing the polarity from V
5
J(MAX)
, the junction-to-ambient thermal resistance,
DS012078-2
www.national.com
IN
to V
JA
, and
OUT