H3DS-SL Omron, H3DS-SL Datasheet - Page 13

• Manufacturer Part Number: H3DS-SL
• Description: TIMER, 4 MODE
• Manufacturer: Omron

Specifications of H3DS-SL

• Contact Configuration: SPDT
• Nom Input Voltage: 230V
• Delay Time Range: 0.1s To 120h
• Relay Mounting: DIN Rail
• Svhc: No SVHC (15-Dec-2010)
• Coil Voltage Vac Nom: 230V
• Coil Voltage Vdc Nom: 24V
• Contact Current Ac Max: 5A

Cat. No. L098-E1-1A
OMRON Corporation
Industrial Automation Company
Measuring and Supervisory Controls Department
28th Fl., Crystal Tower Bldg.,
1-2-27, Shiromi, Chuo-ku,
Osaka 540-6028 Japan
Tel: [phone]/Fax: [phone]
H3DS
The H3DS Series is provided with a transformerless power supply
system.
Input Wires
The input wires must be as short as possible. If the floating capacity
of wires exceeds 2,000 pF (approx. 17 m for cables with 120 pF/m),
the operation will be affected. Pay particular attention when using
shielded cables.
mance
The H3DS as a built-in timer conforms to EN61812-1 provided that
the following conditions are satisfied:
The output section of the H3DS is provided only with basic isolation.
To ensure reinforced isolation required by the EN61812-1, provide
supplementary basic isolation on the load side connected to the out-
put.
The H3DS itself is designed according to the following:
On the above basis:
Operation parts on the front and bottom: Reinforced isolation
– With clearance of 5.5 mm and creepage distance of 5.5 mm at
Output: Basic isolation
– With clearance of 3 mm and creepage distance of 3 mm at
16
Correct
Precautions for EN61812-1 Confor-
Overvoltage category III
Pollution degree 2
230 VAC
230 VAC
Contact or transistor for
external input signal
Short-circuit
current
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
B1
B1
In the interest of product improvement, specifications are subject to change without notice.
H3DS-MLj
H3DS-MLj
A1
A2
A1
A2
Power supply
When using the Timer in an area with excess electronic noise, sepa-
rate the Timer, wiring, and the equipment which generates the input
signals as far as possible from the noise sources. It is also recom-
mended to shield the input signal wiring to prevent electronic inter-
ference.
Organic solvents (such as paint thinner), as well as very acidic or
basic solutions can damage the outer casing of the Timer.
Do not use the Timer in places where it is exposed to dust, corrosive
gas, or direct sunlight.
When storing the Timer, make sure that the ambient temperature
and humidity are within the rated values. Leave the Timer at room
temperature for at least three hours before using the Timer if it has
been stored at an ambient temperature of –10 C or below.
If the Timer is mounted on a control board, dismount the Timer from
the control board or short-circuit the circuitry of the power board be-
fore carrying out a voltage withstand test between the electric cir-
cuitry and non current-carrying metal part of the Timer, in order to
prevent the internal circuitry of the Timer from damage.
Environment
Others
Printed in Japan
0600-3M (0200) (O)
H3DS