RWB4 BANNER ENGINEERING, RWB4 Datasheet - Page 5
![no-image](/images/manufacturer_photos/0/0/91/banner_engineering_sml.jpg)
RWB4
Manufacturer Part Number
RWB4
Description
WIRING BASE FOR MAXI-BEAM SENSORS
Manufacturer
BANNER ENGINEERING
Datasheet
1.RPBA.pdf
(6 pages)
Specifications of RWB4
Leaded Process Compatible
No
Peak Reflow Compatible (260 C)
No
Function
Module, Base Block
Technology
Photoelectric
Lead Free Status / Rohs Status
RoHS Exempt Product
5
Programming the MAXI-BEAM Sensor Head
OPPOSED
MODE
RETRO
MODE
MAXI-BEAM sensor heads may be programmed for sensor response time (and range) and for
LIGHT/DARK operate. Each sensor head is supplied with a programming ring which attaches
below the the sensor head by a system of pegs. There are four programming notches around
the perimeter of the ring. To program the sensor head, simply find the notch which will line
up with the desired program combination (see diagram, right). NOTE: the programming ring
may have to be turned upside-down in order to line up the notch with the program. If LIGHT
OPERATE is selected, the MAXI-BEAM output will energize on a dark-to-light transition.
If DARK OPERATE is selected, the MAXI BEAM output will energize on a light-to-dark
transition. In the illustration, the MAXI-BEAM is set for high speed (HS) operation in the
LIGHT OPERATE output state. See the information about each individual sensor head for
the response time and range associated with each setting (HP, 2W, HS, SP). NOTE: when
programming the RSBE, RSBSER, or RSBEF emitter, select the mode which is programmed
for the receiver. EXCEPTION: if the receiver is programmed for the 2-wire (2W) mode, select
high power (HP) on the emitter.
DIFFUSE
MODE
FIBER OPTIC Mode
Sensing Mode
(glass fibers)
RETROREFLECTOR
OBJECT
OBJECT
OBJECT
RSBFV
Model RSBFV is a
visible-light sensor head
designed for use with
glass fiber optics. It is
compatible with all stan-
dard Banner glass fiber
optic assemblies (see
Banner product catalog).
In order to function
properly, the RSBFV
must be programmed
for the "HS" response
mode. The RSBFV is
not for use with plastic
fiber optics (instead use
RSBFP).
Range: see excess gain
curves
Beam: visible red, 650nm.
Response:
HS mode only, 1ms on/off
Repeatability:
HS = 0.3ms
The model RSBFV will
function only when
programmed for the "HS"
response mode.
The model RSBFV will
not operate with 2-wire
power blocks (models
R2PBA and R2PBB).
Models
Excess Gain
Beam Pattern