HXS 50-NP LEM, HXS 50-NP Datasheet - Page 2

• Manufacturer Part Number: HXS 50-NP
• Description: CURRENT TRANSDUCER
• Manufacturer: LEM

Specifications of HXS 50-NP

• Current Measuring Range Ac: DC, AC, Pulsed, Mixed
• Current Measuring Range Dc: DC, AC, Pulsed, Mixed
• Operating Frequency Range: DC To 50kHz
• Sensor Output: Voltage
• Svhc: No SVHC
• Accuracy: 1%
• Response Time: 5µs
• Current Consumption: 22mA
• Current Range Ac: DC, AC, Pulsed, Mixed
• Current Range Dc: DC, AC,
• Rohs Compliant: Yes
• Accuracy %: 1%
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Current Transducer HXS 50-NP
V
V
V
V
V
Notes :
LEM Components
b
b
d
e
w
Safety :
Caution, risk of danger
Caution, risk of electrical shock
Insulation category
1)
2)
3)
It is possible to overdrive V
between 2 - 2.8 V providing its ability to sink or source approximately
2.5 mA.
Excluding offset and hysteresis.
Small signal only to avoid excessive heatings of the magnetic core.
Nominal Voltage
with IEC 61010-1 standards and following conditions
Nominal Voltage
with EN 50178 standards and following conditions
R.m.s. voltage for AC isolation test, 50/60 Hz, 1 mn
R.m.s. voltage for partial discharge extinction @ 10pC > 1
Impulse withstand voltage 1.2/50µs
- Single insulation
- Over voltage category III
- Pollution degree 2
- Heterogeneous field
- Reinforced insulation
- Over voltage category III
- Pollution degree 2
- Heterogeneous field
REF
with an external reference voltage
This transducer shall be used in accordance with manufacturer instruction.
The temperature of the primary conductor shall not exceed 100°C
Power supply shall be a low voltage source and shall have an efficient
protective system against over current.
Power supply must incorporate a circuit breaker.
This transducer shall be used in an electric/electronic equipment in respect
of standards rules and applicable safety requirements.
Primary bar and output terminals can provide hazardous voltage.
This transducer is a built in device, of which conducting parts must be
inaccessible by installation.
Protective envelope or additional shield must be used.
150
300
2.5
6
V r.m.s.
V r.m.s.
kV
kV
kV
w w w .lem.com