D10UNFPQ BANNER ENGINEERING, D10UNFPQ Datasheet - Page 8

• Manufacturer Part Number: D10UNFPQ
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING
• Type: Analog And Discrete Outputr

Specifications of D10UNFPQ

• Sensor Output: NPN
• Sensor Input: Fiber Optic
• Output Type: Transistor
• Contact Current Max: 150mA
• Switch Terminals: Quick Connect
• Brand/series: D10 Expert™
• Current, Switching: 150 mA
• Function: Fiber Optic
• Ip Rating: IP50
• Mounting Type: DIN Rail
• Output: NPN/Voltage
• Primary Type: Photoelectric
• Sensing Mode: Selectable
• Technology: Photoelectric
• Termination: 6-Wire Connector
• Voltage, Supply: 24 VDC
• Accessories Available: Cordsets and Plastic Fiber Optic Cable
• Fiber Optic Sensor Type: Analog And Discrete Output

• Used to set a single ON condition.
• All other conditions (both lighter and darker) will result in an OFF output.
• Target ON condition sensitivity is adjustable using the “+” and “-” buttons (see Manual Adjust, below).
• May be used at any time sensor is in RUN mode.
• Fine-tunes the sensing thresholds or adjusts sensitivity to the single-point target conditions.
D10 Expert
8
P/N 65448 rev. E
• Press and hold
• Present target to
• Double-click the
• Click “+” to increase,
Static (-) button.
learn.
Static button.
or click “-” to
decrease.
™
Push Button
Push Button
Analog and Discrete Outputs
or
T
T
•
• Present target to learn.
• Single-pulse
• Double-pulse
T
Not available with remote
programming.
Single-Point Static TEACH
the remote line.
the remote line.
T
T
0.04 sec. ≤ T ≤ 0.8 sec.
T
Manual Adjust
Remote
Remote
T
T
T
T
T
T
T
T
T
T
• Display briefly flashes
• Display flashes “inc”
• Display flashes “1st”
• Arrow icon turns red
• Display flashes “2nd”
• Arrow icon turns red
TEACH conditions acceptable:
• Display flashes “sngl,”
• Sensor returns to RUN
• Arrow icon turns green
TEACH conditions unacceptable:
• Display flashes “fail” and
• Arrow icon remains red
• After 60 seconds, sensor
the threshold setpoint
value as it is being changed.
or “dec” as single-point
tolerance is adjusted.
then “pt” twice
mode with new settings.
returns to “1st”
returns to RUN mode
(Arrow icon turns green)
without changing settings.
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
or
T
T
T
T
Result
Result
•
Minneapolis, MN U.S.A.
or