E32-R16 Omron, E32-R16 Datasheet - Page 73

• Manufacturer Part Number: E32-R16
• Description: RETRO REFLECTIVE,1-1.2CM
• Manufacturer: Omron

Specifications of E32-R16

• Rohs Compliant: YES
• Sensing Method: Retroflective
• Sensing Distance: 150 mm to 1500 mm
• Light Source: LED
• Amplifier Type: Separate Digital Amplifier
• Connection: Prewired Cable
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

72
Precautions
■ Accessories
Use of E39-R3 Reflector
1. Use detergent, etc., to remove any dust or oil from the
2. The E39-R3 cannot be used in places where it is exposed
E39-F32 Protective Spiral Tubes
1. Insert a fiber to the Protective Spiral
2. Push the fiber into the Protective
3. Secure the Protective Spiral Tube
4. Use the attached saddle to secure
to oil or chemicals.
surfaces where tape is applied. Adhesive tape will not be
attached properly if oil or dust remains on the surface.
Tube from the head connector side
(screwed) of the tube.
Spiral Tube. The tube should be
straight so that the fiber is not
twisted when inserted. Then turn
the end cap of the spiral tube.
on a suitable place with the
attached nut.
the end cap of the Protective Spiral
Tube. To secure the Protective Spiral
Tube at a position other than the end
cap, apply tape to the tube so that the
portion becomes thicker in diameter.
Mounting panel
Protective
Spiral Tube
Protective
Spiral Tube
Protective
Spiral Tube
Tube
Saddle
End cap
Hexagon
clamping nut
Toothed
washer
Fiber Unit
Fiber Unit
Fiber Unit
E39-F10 Fiber Connector
Mount the Fiber Connector as shown in the following
illustrations.
• The Fiber Units should be as close as possible when they
• Only 2.2-mm dia. fibers can be connected.
are connected.
Sensing distance will be reduced by approximately 25%
when fibers are connected.
Fiber Unit
Retention
unit
①
Splice
Fiber Unit
Retention
unit
Fiber Unit
②
Fiber Unit