ST-18/SMAM/SMAM/36 Huber + Suhner AG, ST-18/SMAM/SMAM/36 Datasheet - Page 2

• Manufacturer Part Number: ST-18/SMAM/SMAM/36
• Description: LEAD, SMA PLUG-SMA PLUG 36 INS
• Manufacturer: Huber + Suhner AG

Specifications of ST-18/SMAM/SMAM/36

• Cable Assembly Type: Audio / Video
• Cable Length: 0.9m
• Outer Insulation Colour: Blue
• Rg Cable Type: SUCOTEST 18
• Svhc: No SVHC (15-Dec-2010)
• Lead Length: 0.9m
• Colour: Blue
• Cable Type: FEP Insulated
• Cable Length - Imperial: 2.95ft
• Cable Length - Metric: 900mm
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The HUBER+SUHNER is certified
according to ISO 9001 and ISO 14001.
Care and handling instructions for HUBER + SUHNER microwave cables
HUBER + SUHNER microwave cable assemblies of
all types offer a long service life providing they are
treated with the appropriate care and attention.
Microwave cable assemblies are high precision
system components and require proper handling in
order to ensure that measuring performance values
are maintained.
To achieve the maximum measuring performance the
following guidelines should be followed:
1. Assemblies should remain in their original packa-
ging for delivery and storage. Storage temperature
should be between -50 °C and +80 °C and the rela-
tive humidity should not exceed 85%.
2. Carefully unpack assemblies before measure-
ment. Avoid kinking cables when straightening from
a coil or reel.
3. Ensure that the surroundings are clean and free
of dust, dirt and any other particles that could enter
unsealed connector interfaces.
4. Use protective caps to prevent contamination
whenever connectors are unmated.
5. Where interfaces are contaminated, particles can
be removed with dry, oil-free compressed air. Please
use eye-protection. Interfaces can be cleaned with
dry cotton swabs. Do not use hard hand-tools or sol-
vents. Do not blow into interfaces or use normal
compressed-air.
WAIVER
While the information contained in this folder has been carefully compiled to the best
of our present knowledge, it is not intended as representation or warranty of any kind
on our part regarding the suitability of the products concerned for any particular use
or purpose and neither shall any statement contained herein be construed as a recom-
mendation to infringe any industrial property rights or as a license to use any such
rights. The suitability of each product for any particular purpose must be checked befo-
rehand with our specialists.
Excellence in connectivity solutions
6. Choose the measurement routing using the largest
bend radii possible. Small bend radii may affect
electrical performance. Exceeding the specified
limits during the measurement process could cause a
permanent degradation.
7. Avoid twisting microwave cable assemblies.
Torsion of this type of assembly can alter the relative
diameters of cable layers and affects the electrical
characteristics. Exceeding the limit of 10° per metre
during measuring process could cause a permanent
degradation.
8. Examine interfaces for damage and/or contami-
nation before mating.
9. Discharge connectors before mating or ensure
that they are connected to a suitable ground.
10. When mating connectors with a screwed inter-
face always hold the connector bodies and turn only
the coupling nut. This avoids twisting the cable and
ensures minimum wear on the connector pins.
11. Do not exceed the torque specified.
HUBER+SUHNER AG
Mobile Communications+Electronics
9100 Herisau/Switzerland
Tel. [phone]
Fax [phone]
www.hubersuhner.com