C5799CP NTE ELECTRONICS, C5799CP Datasheet - Page 6
![MULTI-PURPOSE TOOL, 4 ", STAINLESS STEEL](/photos/20/99/209956/4720690_sml.jpg)
C5799CP
Manufacturer Part Number
C5799CP
Description
MULTI-PURPOSE TOOL, 4 ", STAINLESS STEEL
Manufacturer
NTE ELECTRONICS
Datasheet
1.C7050CP.pdf
(66 pages)
Specifications of C5799CP
Tool Body Material
Stainless Steel
Length
4"
Features
Pliers, Light, Wire Cutter & Stripper, Knife, File, Screwdrivers, Awl, Can Opener, Saw, Scissors
DIGITAL TECHNOLOGY
Continually advancing technology of-
ferings, COAST LED Lenser is featuring
two feature sets with the versatility and
function customers require—the Quick-
cycle Switch System™ and Micro-
controller Switch System—available
on select models. The Quick-cycle
Switch System™ enables users to cycle
between available light output levels,
meaning the user chooses the level of
light needed for their task and decides
how to use the battery life of their light
most efficiently. The Microcontroller
Switch System uses an on-board mi-
croprocessor to differentiate between
five different flows of light output, from
“maximum” to “strobing” light.
10
PRODUCTS
quick-Cycle Switch System™
With this feature, “high” output is the standard setting with each
light, meaning approximately 75% output is the norm, preserving battery
life. Users can always access the light’s “maximum” brightness by
applying momentary pressure to the main switch - simply press and hold
it. To activate the low-output setting from the OFF position, fully
depress and release the switch two times. Low output is useful for
reading, report writing, identification and personal inspections and
maximizes battery run-time.
Press at any time for
maximum output.
Micro Controller Switch System
The LED Lenser Microcontroller Switch System uses a microproces-
sor to allow users full control of the illumination settings of their
light. Using a single switch, the user has the ability to activate the
light at the maximum brightness—ideal for security and tacti-
cal use—as well as taking advantage of the four other settings.
An additional custom setting (a % of output of their choice) is
also available for the user to decide upon and pre-set. Finally,
the light’s three other preset options—signal, strobe and SOS
settings—round out the total of five settings and multiply uses for
the consumer.
The 5 LED Lenser Microcontroller Switch System Settings are:
•
•
•
•
•
Maximum Light Output:
produced by the LED.
Signal:
signal for tactical or emergency situations.
Strobe:
orient an attacker or as a non-lethal weapon for law-enforcement.
SOS:
fast flashes-three long flashes-three fast flashes in sequence.
Variable Light Output:
the light output to suit the task. The light can be adjusted from
a 1%-100% setting to illuminate close-up areas and conserve
batteries, while the higher setting illuminates areas that are
farther away.
projects the international Morse Code distress signal, three
produces a slow blinking light that can be used as a
creates very quick flashes of light that can be used to dis-
this mode enables the user to adjust
projects the maximum amount of light
11