SNAP-B3000-ENET OPTO 22, SNAP-B3000-ENET Datasheet - Page 4

• Manufacturer Part Number: SNAP-B3000-ENET
• Description: Programmable Controller
• Manufacturer: OPTO 22
• Type: Ethernetr

Specifications of SNAP-B3000-ENET

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Brand/series: SNAP Series
• Communication: RS-232
• Current, Input: 1 A
• Data Rate: 2400 to 115200 Kbd
• Dimensions: 3.3"L×1.82"W×4.12"H
• Humidity: 0 to 95%
• Input Type: Analog/Digital
• Interface: IEEE 802.3 (Network), 10 Base-T and 100 Base-TX
• Jumper Type: Boot to Kernel⁄Boot to Loader
• Mounting Type: Rack
• Number Of Expansion Modules: 4, 8, 12/16
• Output Type: Analog/Digital
• Primary Type: Controller
• Serial Port: RS-232
• Temperature, Operating, Maximum: 70 °C
• Voltage, Rating: 5.0 VDC +⁄- 0.1 VDC @ 1.0 A
• Voltage, Supply: 5-5.2 VDC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With: I/O Rack

PAGE
4
Specifications
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • www.opto22.com
SALES 800-321-6786 • 951-695-3000 • FAX [phone] • [e-mail] • SUPPORT 800-835-6786 • 951-695-3080 • FAX [phone] • [e-mail]
© 2006 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
RS-232 Serial Cable
LED Descriptions
100MB
Power Requirements
Operating Temperature
Storage Temperature
Humidity
Network Interface
Serial Port
Serial Data Rates
Maximum Ethernet
Segment Length
Jumpers (Internal)
10MB
ERD
LED
ACT
ETD
FD
Network Activity
Full Duplex Mode
Ethernet—Receive Data
Ethernet—Transmit Data
Ethernet Link Detection at 10 Mbps
Ethernet Link Detection at 100 Mbps
Description
5.0
0 to 70 °C
-40 to 85 °C
0–95% humidity, non-condensing
IEEE 802.3 network, 10Base-T and 100Base-TX
RS-232 (for modem connection using PPP; also for programming and maintenance)
Default is 19,200 baud; baud rate is soft-selectable from 2400 to 115,200 baud.
100 meters with Category 5 or superior UTP.
For 100 Mbps at this distance, use Category 5 or superior solid UTP.
Boot to kernel/boot to loader; reset to factory defaults
–
5.2 VDC at 1.0 A maximum (does not include module power requirements)
Serial Connector Pinouts
Pin
RUN
SRD
STD
LED
3VF
5VF
FLT
1
2
3
4
5
RS-232
Normal Operation
3 Volt Fault
5 Volt Fault
Microprocessor Fault
Serial—Receive Data
Serial—Transmit Data
COM
RTS
CTS
RX
TX
Description
SNAP Ethernet Brains
Pin 1