T1620000 Red Lion Controls, T1620000 Datasheet - Page 7

• Manufacturer Part Number: T1620000
• Description: Process/Temperature Controller
• Manufacturer: Red Lion Controls
• Type: Temperaturer

Specifications of T1620000

• Operating Temperature Max: 50°C
• Operating Temperature Min: 0°C
• Temperature Accuracy ±: 0.3%
• Output Voltage Max: 7V
• Output Voltage Min: 4V
• Controller Input: Thermocouple Or RTD
• Brand/series: T16 Series
• Dimensions: 49.5mmW×49.5mmH×115.3mmD
• Enclosure Rating: IP65
• Input Type: RTD/Thermocouple
• Ip Rating: IP65
• Memory: EEPROM
• Mounting Type: Panel
• Output Type: Digital/SSR
• Power, Rating: 8 VA
• Primary Type: Controller
• Special Features: EEPROM
• Standards: cURus, CE
• Termination: Screw
• Voltage, Supply: 85 to 250 VAC
• Thermocouple Type: J, K, T, E, R, S, B, N, C And Linear MV
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

FRONT PANEL KEYS
DISPLAY LOOP
and the controller’s software version will flash. Then the Temperature/Process
Value is shown in the top display, and the Setpoint Value is shown in the bottom
display. This is the Display Loop. If the Setpoint is hidden or locked, the Display
Loop will default to Output Power. If Output Power is also hidden or locked out,
the bottom display is blank. During programming, the F1 key can be pressed to
return the controller to this point. (Only in the Display Loop will the F1 key
perform the user
4.0 R
5.0 P
At power up, all display segments light, and then the programmed input type
Display Loop. While in the Display Loop, the F1 key can be pressed to
activate its programmed function.
a changed selection/value, and when held for three seconds, enter the
Hidden Loop.
The F1 key is pressed to exit (or escape) directly to the start of the
The Loop key is pressed to advance to the next parameter, to activate
Note: Setpoint and Output Power are the only parameters visible in the Display Loop with Factory Settings. The remaining parameters can
Parameter availability is model and programming dependent.
be selected for the Display Loop within Module 3.
ROGRAMMING
EVIEWING THE
function programmed in Input Module
: D
DISPLAY LOOP
F
.)
RONT
ISPLAY
7
Display Loop. Except for Setpoint and % Output Power, the bottom display
alternates between the parameter name and its selection/value. The arrow keys
are pressed to change the selection/value for the shown parameter. The new
selection/value is activated when the
may be locked out or hidden in Lockout Module
model and programming dependent.
When the
K
EYS AND
L
selections/values and in the Configuration Loop they are used to
scroll to the appropriate Parameter Module.
OOP
The Arrow keys are used to scroll through parameter
is pressed the controller advances to the next parameter in the
D
ISPLAY
is pressed. Display Loop parameters
. Some parameters are