AZH2221 PANASONIC EW, AZH2221 Datasheet - Page 15

• Manufacturer Part Number: AZH2221
• Description: LIMIT SWITCH, ROLLER LEVER, SPDT
• Manufacturer: PANASONIC EW

Specifications of AZH2221

• Actuator Style: Roller Lever
• Operating Force Max: 2.45N
• Contact Voltage Ac Max: 125V
• Contact Voltage Dc Max: 30V
• Contact Current Ac Max: 100mA
• Contact Current Dc Max: 100mA
• Switch Terminals: Screw
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

HOW TO CHANGE THE CORD OUTLET DIRECTION FOR CONNECTOR TYPE
The cord outlet direction is interchange-
able both right and left sides. The direc-
tion of connector cord is set to the right
when it is shipped. When it is used left
side direction, follow the next procedure.
INDICATOR LIGHTING CIRCUIT
(Connector type only)
1) See the circuit diagram.
2) The LED only takes 24 DC V, but
please use a connector designed for AC.
3) Since the LED lamp is connected to
the N.O. side (contact No. 4), please
connect the load to contact No. 4. The
load side should be on the “+” power
supply side. Be careful, because the
LED will break if the connection is
reversed.
Cord outlet direction (Right side)
Push down the fitting metal while pulling
it horizontal direction.
Press up the terminal cover.
• Do not put the lead wire between termi-
nal cover and body.
• Put the seal rubber at the right place.
4) The LED is turned on when the switch
is at a free position. The LED is turned
off when the switch operates.
5) Applicable power source is 24 V DC.
Use it with care on leakage current. The
leakage current is approx. 1.5 mA at 24
V DC.
Step 1
Step 3
Body
Seal rubber
Fitting metal
Terminal cover
Turn the terminal cover at an angle of
180 degree. Follow the step 3.
• Do not pull the terminal cover.
• Do not rotate the terminal cover many
times.
• Do not loosen the terminal screw.
Be careful, because not doing so could
cause wire cutoff and contact failure.
Cord outlet direction (Left side)
Confirm the fitting metal is on tightly.
If it is loosen, it might be cause of the
trouble.
Circuit diagram
Step 2
Step 4
Attention
Resistance
Switch
LED
Contact No. 2
Contact No. 4
Contact No. 3
HL (AZH)
Cramp
Load
Attention
31