03601-86-080R IEE (INDUSTRIAL ELECTRONIC ENGINEERS), 03601-86-080R Datasheet - Page 9

• Manufacturer Part Number: 03601-86-080R
• Description: Vacuum Fluorescent Display Panel
• Manufacturer: IEE (INDUSTRIAL ELECTRONIC ENGINEERS)

Specifications of 03601-86-080R

• Signal Input Type: DC Voltage
• Supply Voltage: 5V
• Character Size: 5mm
• Mounting Type: Surface
• Display Font Color: Green
• Operating Temperature Min: -20°C
• Operating Temperature Max: 70°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

04/30/02
Industrial Electronic Engineers, Inc.
4.10
5.0
5.1
5.2
5.3
5.4
Van Nuys, California
Connector Pin Assignments (Cont’d)
CMOS Note:
ELECTRICAL CHARACTERISTICS
Power ON / OFF Sequence
There are no deleterious effects associated with power ON and OFF of this display; however, rapid ON/OFF
sequencing is not recommended. The power/data connector should not be connected/disconnected while power
is applied.
CAUTION:
Because of the power-up cycle within the microprocessor, rise time of the power supply should be less than
100mS. The display module is not ready to accept data for 500mS
Interface Signals
All logic signals abide by the following convention: logic "1" is a high, logic "0" is a low.
Input Levels:
Logic 1 > 2.4VDC @ 1 A
Logic 0 < 0.5VDC @ 1.6mA
All parallel interface lines are internally pulled up using 10K resistors connected to the +5V supply.
Absolute Maximum Ratings
Primary voltage: +5.5VDC
Logic range:
Normal Operating Ratings
Primary voltage: +5.0
Default Condition - Current Required (at 5.0VDC):
Preproduction
670mA Max.
665mA Typ.
590mA Min.
Care must be taken to insure that input signals do not exceed the supply voltage or ground
levels. Data cables must be as short as possible to reduce signal overshoots.
Do not apply data or strobe signals unless logic power is also applied; otherwise, the input
circuits may be damaged.
0.25VDC
-0.5VDC thru +5.5VDC
Production
620mA Max.
615mA Typ.
540mA Min.
SCALE
SIZE
Output Levels:
Logic 1 > 3.5VDC @ 150 A
Logic 0 < 0.5VDC @ 4mA
A
(Screen filled with “@” character)
(Screen filled with "H" character)
(Screen clear)
CODE IDENT NO.
N/A
05464
REV
D
SHEET
S03601-86-080
9 of 12