B6 OPTO 22, B6 Datasheet - Page 5

• Manufacturer Part Number: B6
• Description: Solid State Relays, Accessories
• Manufacturer: OPTO 22
• Type: Processr

Specifications of B6

• Accessory Type: 16 Position Mounting Board
• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Supply Voltage: 5V
• Mounting Type: Rack
• Number Of Channels: 16
• Power Source: 5
• For Use With: Pamux Protocol
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DATA SHEET
Form 739-010126
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: [phone] • (800) 321-OPTO • Fax: [phone] • www.opto22.com
Setting the Jumpers
address, jumper 6 is disabled, jumper 7 sets the reset line polarity,
and jumper 8 sets the watchdog functionality.
described on the following page.
Jumpers 1–5 (Address)
brain board can control 16 points of analog I/O. Data is passed to
and from the host computer using one address register and one
data register. Each B6 thus requires two consecutive addresses.
address of the B6.
address.
Jumper 6
Jumper 7 (Reset)
line is used to clear all analog outputs on a B6 station to zero
scale, then to set all I/O positions on the B6 to be configured as
inputs. Note that the reset is not intended to be used to shut off
outputs upon a system communication error.
active high or active low, as shown in Table 1. In general, it does
not matter which polarity you select as long as you are consistent
throughout your Pamux system.
The B6 includes eight jumpers. Jumpers 1 through 5 set the
Jumpers 1–5 are described on this page; jumpers 6–8 are
These jumpers configure the base address of the B6. The
Refer to Figure 7 at right to determine how to set the base
Note that each Pamux station on a bus must have a unique
Jumper 6 has been disabled and has no effect.
One of the control lines on the Pamux bus is the reset line. This
Jumper 7 determines the polarity of the reset line, either
Inside Sales: (800) 321-OPTO • Product Support: (800) TEK-OPTO • [phone] • Fax: [phone] • E-mail: [e-mail]
Table 1: Reset Jumpers
Reset Level
B6 INSTALLATION NOTES
Active High
Active Low
BRAIN BOARDS
Figure 7: Address Jumpers
Jumper 7
Out
In
CLASSIC
page 5/6