SNAP-PAC-RCK8 OPTO 22, SNAP-PAC-RCK8 Datasheet - Page 5

• Manufacturer Part Number: SNAP-PAC-RCK8
• Description: Mounting Rack
• Manufacturer: OPTO 22
• Type: Mounting Racksr

Specifications of SNAP-PAC-RCK8

• Accessory Type: 8 Module Mounting Rack
• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Mounting Type: Rack Mount
• For Use With: SNAP I/O Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

SNAP PAC Racks
Mounting the Extrusion onto a Panel
NOTE: If you are not using hold-down screws, the SNAP PAC rack
assembly should be mounted horizontally.
Use the following steps to mount a rack onto a panel. For DIN-rail
mounting, see form #1772, the SNAP TEX Mounting/Wiring and
Spare Parts Data Sheet.
Preferred Method: Template
(Product on site)
1.
2.
© 2007–2010 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
Typical Plain View of SNAP Mounting Extrusion
Center-to-Center Length (All Models)
SNAP-PAC-RCK12 (or -FM)
SNAP-PAC-RCK16 (or -FM)
SALES 800-321-6786 • 951-695-3000 • FAX [phone] • [e-mail] • SUPPORT 800-835-6786 • 951-695-3080 • FAX [phone] • [e-mail]
Use SNAP PAC rack mounting extrusion as template.
Use the diagram below to determine required product and
option clearances.
SNAP-PAC-RCK4 (or -FM)
SNAP-PAC-RCK8 (or -FM)
Part Number
12-module rack
16-module rack
4-module rack
8-module rack
Description
Center-to-Center
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • www.opto22.com
Length
4.02 in.
3.51 in.
5.01 in.
4.34 in.
Alternate Method: Prefabrication of Panels
(No product on site)
Mounting holes are in sets of two, located on lower left and upper
right with respect to a center line (CL).
1.
2.
3.
Using the diagram below, determine CL1 mounting hole posi-
tions. (CL1 is located on the left side of all SNAP PAC rack
mounting extrusions.)
Use the center-to-center length specification table below to
determine the offset between center lines and the number of
center line positions for each model.
Repeat the process for each center line position.
Number of Center
Positions
2
3
3
4
PAGE
5