INFRESCO P 6KW UNITED AUTOMATION, INFRESCO P 6KW Datasheet - Page 4

• Manufacturer Part Number: INFRESCO P 6KW
• Description: INFRESCO, PIR 6KW
• Manufacturer: UNITED AUTOMATION

Specifications of INFRESCO P 6KW

• Operating Temperature Max: 40°C
• Operating Temperature Min: -20°C
• Approval Bodies: CE
• External Depth: 75mm
• External Length / Height: 130mm
• Ip/nema Rating: Load Power
• For Use With: Quartz Infrared Halogen Lamps
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WIRING OPTION 1
WIRING OPTION 2
DIMENSIONS
Commissioning
Turn the lamp on-time preset (VR2) fully anti-clockwise to select ‘walk test’ mode. Check
the PIR sensitivity preset (VR3) is set to approximately the half-way position (factory
default). The temperature set point preset (VR1) is ignored in ‘walk west’ mode.
Switch on the mains supply to the unit. The controller waits 60 seconds to allow the PIR
sensor to stabilise. The detection area can then be walk tested to verify the PIR’s
coverage. Each time the PIR detects sufficient movement, the lamps will switch on for 5
seconds.
Note: Each time the lamps switch off, the PIR is inhibited for 5 seconds to
prevent changes in infrared energy given off by the lamps from causing a false
activation.
Once the detection area and range have been verified, adjust the on-time preset to
between 5 and 30 minutes. This will automatically disable ‘walk test’ mode.
The temperature set point preset should now be set as required.
Note: If the ambient temperature exceeds the set point temperature, the lamps
are inhibited.
The PIR sensitivity preset can also be adjusted if necessary. Turning the preset
clockwise increases the sensitivity.
Note: Increasing the PIR sensitivity may also increase the likelihood of PIR false
activations.