G303M000 Red Lion Controls, G303M000 Datasheet - Page 2

• Manufacturer Part Number: G303M000
• Description: LCD, 128 X 64 Indoor
• Manufacturer: Red Lion Controls
• Type: Color Graphicr

Specifications of G303M000

• Dimensions: 7.45 W × 5.85 H In.
• Display Size: 3 In.
• Keypad Type: 32 Button Keypad
• Memory: 4 Mb Flash
• Mounting Type: Panel
• Primary Type: Operator Interface
• Resolution: 128 × 64 Pixel LCD
• Resolution, Display: 128 × 64
• Size: 3 In. Mono LCD
• Standards: CE Approved, cULus Listed
• User Interface: Keypad
• Voltage, Supply: 24 V
• Configuration Is Stored In Non-volatile Memory: 4 Mbyte Flash for G306M
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: Hazardous Locations

1. POWER REQUIREMENTS:
2. BATTERY: Lithium coin cell. Typical lifetime of 10 years.
3. DISPLAY: 3.2" 128 x 64 pixel FSTN LCD with yellow LED backlight for
4. 32-KEY KEYPAD: 8 user legendable keys, 5 navigational keys, 10+2
5. MEMORY:
6. COMMUNICATIONS:
7. ENVIRONMENTAL CONDITIONS:
S
DIMENSIONS In inches (mm)
+24 VDC ±20% @ 9.5 W maximum. Must use Class 2 or SELV rated power
Power connection via removable three position terminal block.
Notes:
characters and simple graphics applications.
numeric keys, 4 dedicated keys, and 3 soft keys for on-screen menus.
On Board User Memory: 4 Mbyte of onboard non-volatile Flash memory.
Memory Card: CompactFlash Type II slot for Type I and Type II
USB Port: Adheres to USB specification 1.1. Device only using Type B
Serial Ports: Format and Baud Rates for each port are individually software
Ethernet Port: 10 BASE-T / 100 BASE-TX
Operating Temperature Range: 0 to 50°C
Storage Temperature Range: -30 to 70°C
Operating and Storage Humidity: 80% maximum relative humidity (non-
Altitude: Up to 2000 meters.
PECIFICATIONS
supply.
1. The front panel PWR LED indicates power.
2. The G303’s circuit common is not connected to the enclosure of the unit.
CompactFlash cards.
connection.
programmable up to 115,200 baud.
PGM Port: RS232 port via RJ12.
COMMS Ports: RS422/485 port via RJ45, and RS232 port via RJ12. These
DH485 TXEN: Transmit enable; open collector, V
Note: For additional information on the communications or signal
RJ45 jack is wired as a NIC (Network Interface Card).
condensing) from 0 to 50°C.
See “Connecting to Earth Ground” in the section “Installing and
Powering the G303”.
two ports share the same hardware; the G303 multiplexes the ports to
communicate via two protocols. These ports may be used to configure
different master protocols, but only one port may be used if configuring
a slave protocol or AB DH485.
V @ 25 mA max.
common and connections to earth ground please see “Connecting to
Earth Ground” in the section “Installing and Powering the G303”.
WARNING - DO NOT CONNECT OR DISCONNECT CABLES
WHILE POWER IS APPLIED UNLESS AREA IS KNOWN TO BE
NON-HAZARDOUS. USB PORT IS FOR SYSTEM SET-UP AND
DIAGNOSTICS AND IS NOT INTENDED FOR PERMANENT
CONNECTION.
OH
= 15 VDC, V
OL
= 0.5
2
8. CERTIFICATIONS AND COMPLIANCES:
9. CONSTRUCTION: Steel rear metal enclosure with NEMA 4X/IP66
10. MOUNTING REQUIREMENTS: Maximum panel thickness is 0.25" (6.3
11. WEIGHT: 1.96 lbs (0.89 Kg)
SAFETY
UL Recognized Component, File #E179259, UL61010-1, CSA 22.2 No. 61010-1
UL Listed, File #E211967, UL61010-1, UL1604, CSA 22.2 No. 61010.1,
IECEE CB Scheme Test Certificate #US/9737/UL
ELECTROMAGNETIC COMPATIBILITY
Emissions and Immunity to EN 61326: Electrical Equipment for
Notes:
aluminum front plate when correctly fitted with the gasket provided.
Installation Category I, Pollution Degree 2.
mm). For NEMA 4X/IP66 sealing, a steel panel with a minimum thickness of
0.125" (3.17 mm) is recommended.
Maximum Mounting Stud Torque: 17 inch-pounds (1.92 N-m)
Immunity to Industrial Locations:
Electrostatic discharge
Electromagnetic RF fields
Fast transients (burst)
Surge
RF conducted interference
Emissions:
Emissions
Recognized to U.S. and Canadian requirements under the Component
Recognition Program of Underwriters Laboratories, Inc.
CSA 22.2 No. 213-M1987
LISTED by Und. Lab. Inc. to U.S. and Canadian safety standards
Type 4X Enclosure rating (Face only), UL50
CB Scheme Test Report #E179259-V01-S04
IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment
IP66 Enclosure rating (Face only), IEC 529
Measurement, Control and Laboratory use.
1. Criterion A: Normal operation within specified limits.
2. Criterion B: Temporary loss of performance from which the unit self-
Issued by Underwriters Laboratories Inc.
recovers.
for measurement, control, and laboratory use, Part 1.
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 55011
Criterion A
4 kV contact discharge
8 kV air discharge
Criterion A
10 V/m
Criterion A
2 kV power
1 kV signal
Criterion B
1 kV L-L,
Criterion A
3 V/rms
Class B
2 kV L&N-E power