RM0008N50 HAMMOND POWER SOLUTIONS, RM0008N50 Datasheet - Page 14

• Manufacturer Part Number: RM0008N50
• Description: Line Reactor
• Manufacturer: HAMMOND POWER SOLUTIONS
• Series: RMr

Specifications of RM0008N50

• Suppressor Type: Line Reactor
• Power Consumption: 31W
• Supply Voltage Range: 240VAC To 600VAC
• Phase Type: 3 Phase
• Output Current: 8A
• Inductance: 5mH
• Switching Frequency: 20kHz
• Length: 86.11mm
• Width: 111.76mm
• Brand/series: RM Series
• Current, Rating: 8 A
• Frequency, Operating: 60 Hz
• Impedance: 5%
• Power, Rating: 1.5 HP
• Standards: UL File No.: E61431, CSA File No.: LR 3902 and CE Mark (IEC 61558- 2-20-2000:)
• Voltage, Rating: 240 VAC
• Height: 86.36mm
• Power Rating: 3hp
• Rohs Compliant: Yes
• Supply Voltage: 600V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Installed on the input side of drives, reactors will reduce line notching, limit
current and voltage spikes and surges from the incoming line, and will reduce
harmonic distortion from the drive onto the line. Units are installed in front of the
drive or inverter as shown.
Individual line reactors are recommended when multiple drives are installed on
the same power line. Individual reactors eliminates cross talk between multiple
drives and provides isolated protection for each controller for its own specifi c
load.
SECTION 3
© Hammond Power Solutions Inc.
A1
B1
C1
Application and Connection Diagrams
A1
B1
C1
B1
C1
A1
INPUT SIDE OF DRIVE
MULTIPLE DRIVES
A2
B2
C2
A2
B2
C2
A2
B2
C2
Drive
Open Style Ref.
above 200 amps
80 to 200 amps
Drive
Drive
All Others:
Figure #1
Figure #2
Figure #3
Termination Details
Motor
Motor
Motor
CONNECTOR DETAIL
DIAGRAM 1
Terminal Block
Terminal Block
Terminal Block
Terminal Pad
Terminal Pad
122
Type
RM SERIES LINE REACTORS
On the output side between the motor and the controller, reactors protect the
controller from short circuits at the load. Motor performance improves. Voltage
and current waveforms from the supply are enhanced reducing motor overheat-
ing and noise emissions.
A single reactor can be installed when the application calls for multiple motors
on the same drive. The reactor is sized based on the total horsepower of all the
motors. Recommended for simultaneous operating motors only.
Drive
Drive
1A - 0.313” Dia.
1B - 0.500” Dia.
.313” dia.
.5” dia.
OUTPUT SIDE OF DRIVE
Range/Dia.
#12 - #22
#4 - #18
#4 - #18
MULTIPLE MOTORS
A1
B1
C1
A1
B1
C1
(diagram 1B)
(diagram 1A)
Data subject to change without notice.
A2
B2
C2
A2
B2
C2
Motor
Motor
Motor