2MBI300U2B-060-50 FUJI ELECTRIC, 2MBI300U2B-060-50 Datasheet - Page 12

• Manufacturer Part Number: 2MBI300U2B-060-50
• Description: DUAL IGBT MODULE 300A 600V NPT
• Manufacturer: FUJI ELECTRIC

Specifications of 2MBI300U2B-060-50

• Module Configuration: Dual
• Transistor Polarity: N Channel
• Dc Collector Current: 300A
• Collector Emitter Voltage Vces: 2.45V
• Power Dissipation Max: 1kW
• Collector Emitter Voltage V(br)ceo: 600V
• Transistor: RoHS Compliant

a
Warnings
This product shall be used within its absolute maximum rating (voltage, current, and temperature). This product
may be broken in case of using beyond the ratings.
Connect adequate fuse or protector of circuit between three-phase line and this product to prevent the equipment
from causing secondary destruction, such as fire, its spreading, or explosion.
Use this product after realizing enough working on environment and considering of product's reliability life.
This product may be broken before target life of the system in case of using beyond the product's reliability life.
When electric power is connected to equipments, rush current will be flown through rectifying diode to charge
2
DC capacitor. Guaranteed value of the rush current is specified as I
t (non-repetitive), however frequent rush
current through the diode might make it's power cycle destruction occur because of the repetitive power.
In application which has such frequent rush current, well consideration to product life time (i.e. suppressing
the rush current) is necessary.
2
2
I
t(
)
I
t
If the product had been used in the environment with acid, organic matter, and corrosive gas ( hydrogen sulfide,
sulfurous acid gas), the product's performance and appearance can not be ensured easily.
Use this product within the power cycle curve (Technical Rep.No. : MT5F12959). Power cycle capability is
classified to delta-Tj mode which is stated as above and delta-Tc mode. Delta-Tc mode is due to rise and down
of case temperature (Tc), and depends on cooling design of equipment which use this product. In application
which has such frequent rise and down of Tc, well consideration of product life time is necessary.
(
No.: MT5F 2959)
Tj
Tc
(Tc)
Never add mechanical stress to deform the main or control terminal. The deformed terminal may cause poor
contact problem.
Use this product with keeping the cooling fin's flatness between screw holes within 100um at 100mm and the
roughness within 10um. Also keep the tightening torque within the limits of this specification. Too large convex
of cooling fin may cause isolation breakdown and this may lead to a critical accident. On the other hand, too
large concave of cooling fin makes gap between this product and the fin bigger, then, thermal conductivity will
be worse and over heat destruction may occur.
100mm 100um
10um
In case of mounting this product on cooling fin, use thermal compound to secure thermal conductivity. If the
thermal compound amount was not enough or its applying method was not suitable, its spreading will not be
enough, then, thermal conductivity will be worse and thermal run away destruction may occur.
Confirm spreading state of the thermal compound when its applying to this product.
(Spreading state of the thermal compound can be confirmed by removing this product after mounting.)
(
)
It shall be confirmed that IGBT's operating locus of the turn-off voltage and current are within the RBSOA
specification. This product may be broken if the locus is out of the RBSOA.
RBSOA
RBSOA
a
12
MS5F 5617
13
H04-004-03a